Where do you put an ice dam melt sock?

Answer 1

If you have never used a ice dam melting sock on your roof before, you will find that they provide an inexpensive method for removing roof ice dams and improving your home's heating efficiency. Roof ice dams are an annoying source of roof damage, leaks, and heat loss in the winter. The main causes are drip melt from improperly capped warm air vent pipes and poor roof insulation. Laying a ice melt sock onto the roof so it crosses the ice dam and overhangs the gutter, will melt through the snow and ice and create a channel for water to flow down into the gutters or off the roof. If done properly those icicles that form as the snow melts from the edges of the gutters will never appear.

Answer 2

You can fill and refill the ice melt socks with off the shelf ice melt. Simply open the Velcro strap at top of socks, fill with off the shelf "ice melt" from any hardware store, and reclose the strap tightly, bottom knots for the pull cord, attach your own nylon throw cord and throw or place at troubled roof areas where ice dams are evident. Allow the throw cord to hang over the edge of the roof. Leave in place all winter or use approximately 20-foot pull cord to retrieve.

Answer 3

You can fill and refill the ice melt socks with off the shelf ice melt. Simply open the Velcro strap at top of socks, fill with off the shelf "ice melt" from any hardware store, and reclose the strap tightly, bottom knots for the pull cord, attach your own nylon throw cord and throw or place at troubled roof areas where ice dams are evident. Allow the throw cord to hang over the edge of the roof. Leave in place all winter or use approximately 20-foot pull cord to retrieve. You can fill and refill the ice melt socks with off the shelf ice melt. Simply open the Velcro strap at top of socks, fill with off the shelf "ice melt" from any hardware store, and reclose the strap tightly, bottom knots for the pull cord, attach your own nylon throw cord and throw or place at troubled roof areas where ice dams are evident. Allow the throw cord to hang over the edge of the roof. Leave in place all winter or use approximately 20-foot pull cord to retrieve.

Answer 4

Ice Dam Melting Socks

If you have ever used a "Snow Melt Sock" before, you know that they provide an inexpensive method for removing roof ice dams and improving your home's heating efficiency. Roof ice dams are an annoying source of roof damage, leaks, and heat loss in the winter. The main causes are drip melt from improperly capped warm air vent pipes and poor roof insulation. Laying a snow melt sock onto the roof so it crosses the ice dam and overhangs the gutter, will melt through the snow and ice and create a channel for water to flow down into the gutters or off the roof. If done properly those ice sickles that form as the snow melts from the edges of the gutters will never appear, they too are a cause of much damage and are dangerous to life and limb.

Refillable Snow Melt Sock breaks ice dams in minutes by creating ice channels to drain water. Just place and forget it for the winter. The socks are available full of non-staining ice melt or empty for you to fill.

Snow Melt Socks remove ice dams to prevent water damage to ceilings, windowsills, wood floors, and carpets.

Empty Snow Melt Sock is a nylon sock; this nylon sock can be used again and again to remove ice dams from your roof. Empty Snow Melt Sock does not include Ice Melt or throw cord. Typical filled sock weights 3 pounds, is 18 inches long, Snow Melt Sock lasts for months. This is based on melt of 20-40 Square yards of roof snow per sock used. Place one sock every 10-15 feet at right angles above channel eaves and gutters. Reuse sock until empty.

After use allow socks to dry naturally. Store in well-ventilated area.

Purchase only environmentally friendly 100% nylon socks.

A Snow Melt Sock can last all winter and keep a 20 square foot area clear of ice dams depending on roof angle, sock placement, and rain/snowfall.

You can fill and refill the Snow Melt Socks with off the shelf ice melt. Simply open the Velcro strap at top of sock, fill with off the shelf "ice melt" from any hardware store, and reclose the strap tightly bottom knots on the pull cord, attach your own nylon throw cord and throw or place at troubled roof areas where ice dams are evident. Allow the throw cord to hang over the edge of the roof. Leave in place all winter or use 20-foot pull cord to retrieve.

Most manufacturers can make socks to any length and can prefill them at a reasonable price plus shipping.

You can purchase the "ice melt" with the socks and fill and refill as needed.

Answer 5

Ice dams melt socks should be placed on the roof near the ice dam, with one end hanging over the edge of the roof. This allows the filled sock to release calcium chloride onto the ice dam, helping to melt it from the bottom up.