If the stove is rated for 30 amps then 10 wire would be enough. However if the stove is rated for 40 8 wire would be needed, 50 6 wire
427cm
To carry the electric power to a light . . OR . . it's wire that is not too heavy to carry.
No. It is a physical process cause be passing an electric current through a wire.
The wires must first be heat resistant. For that the best wires that can be used are wires made up of superconductors.
I just used it to run my 50 amp electric stove. You can use it for a small sub-panel.
Yes. Since you want your breaker to be less than the maximum rating of the receptacle this would be fine.
If you're asking here, then you don't know enough about electricity. It might even be illegal to do this yourself if you are unqualified. Get an electrician.
Normally a new kitchen stove will require a 50 amp breaker wired with AWG # 6/3 with ground wire.
To carry the electric power to a light . . OR . . it's wire that is not too heavy to carry.
No. It is a physical process cause be passing an electric current through a wire.
strong
The wires must first be heat resistant. For that the best wires that can be used are wires made up of superconductors.
Always. Check the spec for amps and use an online calculator to figure for wire size.
I just used it to run my 50 amp electric stove. You can use it for a small sub-panel.
You only get an electric shock if you are touching both the ground and the electric wire, (or close enough to both for the electricity to arc) Birds sat on electricity cables are not close enough to the ground for the electricity to arc, therefore they do not get shocked.
Change the cord/plug on the stove to a four wire cord/plug. When installing the new plug remove the grounding strip that connects the center lug in the stove wiring block to the frame of the stove. Connect the white wire from the new plug to the center lug. Connect the green wire from the plug to the stove frame.
Yes. Since you want your breaker to be less than the maximum rating of the receptacle this would be fine.
No. Each circuit has to have its own dedicated circuit. The breaker and wire size differ between the two appliances.