You will need some other measurements to make it possible, since those are two different units of measurement. mph (or Miles Per Hour) is a measurement of speed, whereas psi (or Pounds Per square Inch) is a measurement of pressure. There is no direct conversion between them, however, if you know the volume of flow and the area it has to flow through, it should be possible to calculate.
For example:
A leaf blower rated at 450 cfm @ 250 mph when blowing through a 4 inch diameter pipe will produce "x" psi.
So you need the flow rate and diameter to finish the conversion.
To convert PN25 to PSI, you can use the conversion factor where 1 PN (Pressure Nominal) is equivalent to approximately 145 PSI. Therefore, to convert PN25 to PSI, multiply 25 by 145. This results in approximately 3625 PSI.
To convert 14.73 psi to 15.025 psi, you need to increase the pressure by the difference between the two values. Subtract 14.73 from 15.025, which gives you 0.295 psi. Therefore, you can achieve the conversion by adding 0.295 psi to 14.73 psi, resulting in 15.025 psi.
Multiply psi by 0.006894759086775369 to convert from psi to MPa. ex: 1000 psi = 1000 x 0.006894759086775369 = 6.89 MPa http://www.chapelsteel.com/psi-mpai.html
190 kPa is equivalent to approximately 27.56 psi.
If we have six (6) feet of water, that will convert to about 2.6 psi (pounds per square inch).
Minimum oil pressure--- At 1000 RPM is 6 PSI At 2000 RPM Is 18 PSI At 4000 RPM is 24 PSI Anything over that is fine, as long it don't excead over 65 PSI.
03 GMC Sonoma with the 4.3L Engine: @ 1000 RPM - Minimum of 6 PSI @ 2000 RPM - Minimum of 18 PSI @ 4000 RPM - Minimum of 24 PSI 03 GMC Sonoma with the 2.2L Engine: Minimum of 56 PSI @ 3000 RPM
Multiply psi x 0.07 to get atmospheres.
Anywhere from 35-65 psi. Higher psi at higher RPM's. Lower at lower RPM's.
Probably 5 psi to 60 psi.
1 bar = 14.5 PSI
To convert 14.73 psi to 15.025 psi, you need to increase the pressure by the difference between the two values. Subtract 14.73 from 15.025, which gives you 0.295 psi. Therefore, you can achieve the conversion by adding 0.295 psi to 14.73 psi, resulting in 15.025 psi.
To convert from torr to psi, divide by 51.715. Therefore, 752 torr is approximately 14.55 psi when rounded to two decimal places.
Multiply psi by 0.006894759086775369 to convert from psi to MPa. ex: 1000 psi = 1000 x 0.006894759086775369 = 6.89 MPa http://www.chapelsteel.com/psi-mpai.html
110 - 130 Scfn is what in psi
Multiply psi by 144 to get psf.
To convert 0.50 MPa to psi, you can use the conversion factor: 1 MPa is approximately equal to 145.038 psi. Therefore, 0.50 MPa is approximately equal to 72.519 psi.