0
A service drop to a residence is connected to the utility's---- voltage?
Wiki User
∙ 14y ago
secondary
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What type of voltage must be connected to a d'arsonval meter movement?
dc voltage
What is the output when a secondary voltage of 24V is connected to bridge rectifier when no load is connected?
24VACRMS * 1.414 = 33.94VACPEAK The unloaded filtered DC voltage is 33.94V The unloaded unfiltered voltage will be a single polllarity AC voltage with a peak of 33.94V
Can ups be connected to inverter?
Ups can be connected to an inverter since it does not exceed the rated voltage
Why black wire and white wire both have power?
In the US, house wire has the BLACK wire connected to the HOT phase of the service input. The WHITE wire is connected to the NEUTRAL of the service input. Normally, both BLACK and WHITE wires are each connected to the 2 LOAD terminals. It is also normal that the WHITE service wire is connected to the wider spade outlet receptacle. The BLACK wire would then be connected to the shorter or narrower outlet spade receptacle. In wired screw lamp circuits, it is normal to wire the BLACK service wire to the center pad of the lamp socket and the WHITE wire to the screw shell of the socket. In switch circuits, it is normal to wire the BLACK service wire to the switch. The HOT service circuit is then opened or closed by the switch. Measuring voltage on your neutral means there is a break in neutral. If the neutral is broken you will measure voltage across the break or from the break to ground. Under this scenario you will measure the same voltage as you do on your hot wire and your load should not be working. Measuring voltage on your neutral less than on your hot wire may mean you have a problem where your neutral is supposed to be bonded to ground in your main service panel. In this scenario your load may be working but you need to check the bonding connection.
Two voltage sources can be connected in parallel when they are equal in?
Voltage sources connected in parallel should have equal voltage. Otherwise the stronger battery would attempt to charge the weaker creating a lot of heat and depending on the type of battery there is the chance of explosion.
What is the voltage and amp service at the street before it steps down to the residence?
The voltage and ampacity can vary depending on the demand of the neighborhood. The voltage is typicaly 240 volt with the amperage capacity varying. 7,200 volts goes to the transformer on the pole, amperage varies.
High voltage field windings are connected series or parallel?
high voltage field windings are connected in parallel
Is a parallel connected D.C voltage power source additive voltage or contant voltage?
Constant voltage
Why bulbs connected inparallel?
all the bulbs must in parallel because all must get the same voltage.......in parallel voltage is constant.if they are connected in series they will not get same voltage
When batteries are connected in parallel what happened with their voltage?
The voltage remains the same.
Is line voltage or phase voltage mentioned on transformer nameplate?
It depends how they are connected. If they are connected between line conductors then they are measuring line voltages. If they are connected across phases then they are measuring phase voltages.
What type of voltage must be connected to a d'arsonval meter movement?
dc voltage
When measuring voltage the probes should be connected in?
can some one please tell me when measuring voltage the probes should be connected to sequence or series?
If additional resistance is connected in parallel with a circuit the supply voltage will decrease?
If additional resistance is connected in parallel with a circuit the supply voltage will decrease?
What happens to supply voltage if additional resistance is connected in parallel circuit?
No change in supply voltage as additional resistance is connected in parallel circuit.
How can cells be connected together to get a higher voltage?
cells must be connected in series
What is the output when a secondary voltage of 24V is connected to bridge rectifier when no load is connected?
24VACRMS * 1.414 = 33.94VACPEAK The unloaded filtered DC voltage is 33.94V The unloaded unfiltered voltage will be a single polllarity AC voltage with a peak of 33.94V
