answersLogoWhite

0

Can you run a mixer through audio speakers?

Updated: 8/17/2019
User Avatar

Wiki User

13y ago

Best Answer

In most cases you need 4 parts:

1- Input(microphone, iPod, CD player, radio, etc)

2- Mixer

3-amplifier

4- speakers

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you run a mixer through audio speakers?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is there any way to hook up headphones to cable TV without cutting out the TV sound?

Run the audio through a receiver and speakers. Most receivers will let you hook up headphones and the speakers can either be on or off.


Can you plug an ipod into your 2007 buick lucerne?

Of course you can. Run an audio cable like for your PC speakers from the audio jack on the Lucerne to your iPod. All done!


How do i connect my tv which is a Digital Audio Out connection to my computer speakers which have a 3.5mm Headphone Jack connection so that my TVs sound will play out of the speakers?

Unless your computer speakers have a digital audio input, you won't be able to just use a cable. If your TV has two RCA line outputs (audio outputs), you can get an adapter cable to run to your computer speakers. You could upgrade your speakers to models that have a digital input, but most of those are higher-end surround-type systems.


How can I install ceiling speakers into my bathroom?

You'd need to run the wires from your audio source up into your attic and then install the speakers. If your bathroom isn't on the top floor you should use wallspeakers.


Can I run a mixer through my powered mixer for drum mics?

Yes. In fact, I would recommend doing this instead of just running the mics through your band's powered mixer. That way, all your drum sounds (pre-mixed) will fit into just one input on your band's powered mixer. It takes about a minimum of 6 or 7 mics to capture a drum kit properly and that's a hell of a lot of inputs to be using on your band's P.A. Just run the mics through your own mixer, then run your mixer's "Main 1" output to your band's P.A. input. Use a balanced cable. Also, if the mixer that you are using is unpowered, then get yourself a couple powered monitors to run directly off of it so you can have some monitoring without using one of the the P.A. monitors. If your drum mixer IS powered, however, just get yourself some speakers and you've got yourself some monitors. In a nutshell, I recommend getting a small powered mixer for your drum mics (something with 100W minimum) with unpowered monitors running right off of it (use the "Main 2" output). Connect the mixer's "Main 1" output to your band's P.A. system for the final mix. But remember, if you do it like this, you have to dial in a good mix on your drum mics through your own little mixer because the sound guy will only be able to adjust the volume of the drum kit AS A WHOLE through the main P.A. system. This is what I do and it works very well.


My tv doesn't have any audio output jacks. Can you disconnect the wires going to the tv speakers and run them into your stereo audio inputs without creating to bad of an impedance mismatch?

yes it is possible by using a high low converter. the out put where the speakers are must be converted to low output.


What equipment do you need to run the program cubase?

A reasonably fast PC/Mac External Soundcard with low latency (onboard sound not good enough) Monitors and/or speakers Mixer (optional)


Can you run a mixer without electricity?

no


What is a usb mixer for recording and What would be better than the mbox2 with pro tools 8?

A USB Mixer is an audio mixer with a built-in USB audio interface. It is sometime better than a stand-alone interface since you can plug in more microphones and instruments at once. They usually get mixed to a stereo mix, so it isn't possible with most of these mixers to track a drum kit or other instrument that requires a lot of mics and individual tracks. You can't use a USB mixer with Pro Tools 8. Pro Tools LE 8 only works with the MBox and the Digi 002/003 hardware from Avid. Pro Tools M-Powered 8 works with M-Audio USB and Firewire audio interfaces. If you want to run Pro Tools 9 (the current version), you can use any USB mixer that has ASIO (PC) or Core Audio (Mac) drivers.


Can you rewire a mixer 120 volt motor to run a 220 volts?

No, you will need a commercial mixer for that.


How do you hook up a crossover to your car audio?

Read the sides. Put inputs left and right in the correct slots. you can get input from speaker wire coming from speakers already in your car that is hooked in to the radio or amp. Then run wires to the speakers


Can I plug my home speakers into my computer?

No most home speakers are supposed to be powered through an amplifier. A computer will not supply enough power to effectively run those speakers. Plus the wiring for computer and home speakers are very different.