Yes, the needle would point perpendicular to the wire, and parallels to the magnetic lines of the wire.
Another answer The above answer would be correct IF you were dealing with a DC circuit AND there was a load on the circuit, but house wiring uses Alternating Current, and the compass needle would attempt to reverse directions at the rate of 60 cycles per second. Effectively, the needle would simply act strange when it's near house wiring, IF there is a current load on the wire.
++
To add to that, use a proper cable-locator, not a compass.
No, the magnetic field brought about by current flow would not be detected by a compass. Any field that was present would be cancelled out by the approximation of the parallel conductor on the return leg of the circuit.
Light switches can be purchased from SparkyDirect, they have a huge range of light switches other websites offering light switches are HomeBase, argos and ebay.
It is dependant on whether the switches are in wired in a parallel or series configuration. If the switches are wires in parallel then both switches would have to be off to turn the light bulb off. Either switch could turn the light bulb on. If the switches are wired in series then both switches would have to be on to turn the light bulb on. Either switch could turn the light bulb off.
Modern light switches are made from plastic, copper, and (maybe) coiled steel springs.
Dimmer switches go bad, more often than regular switches.
the oulets yes the switches would be a no
Light switches can be purchased from SparkyDirect, they have a huge range of light switches other websites offering light switches are HomeBase, argos and ebay.
Compass Light was created in 1985.
It is dependant on whether the switches are in wired in a parallel or series configuration. If the switches are wires in parallel then both switches would have to be off to turn the light bulb off. Either switch could turn the light bulb on. If the switches are wired in series then both switches would have to be on to turn the light bulb on. Either switch could turn the light bulb off.
Modern light switches are made from plastic, copper, and (maybe) coiled steel springs.
the compass safe because is light and easy-to-carry.
In a light switch factory......
Yes, because the light is using 3-way switches. There is always "power" travelling between the switches.
Dimmer switches go bad, more often than regular switches.
The single light will not come on. The traveler legs from the two switches will have to be opened simultaneously if they are not then you will get a flick of light.
the oulets yes the switches would be a no
Mercury tilt switch, Knife switch, Footswitch, Reversing switch, Light switches, Electronic switches
Two possibilities; the dash switch is set to ON that operates the interior lights, or one or more of the switches that detect a door open has failed.