0
How do you change the cam sensor on a 1996 Chrysler Sebring 2.5?
Wiki User
∙ 10y ago
You have to buy and replace the entire distributor.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Where is the mass air flow sensor on a 1996 Chrysler sebring convertible?
A 1996 Chrysler Sebring does not have a mass airflow sensor.
How do you reset the battery in a 1996 Chrysler Sebring?
There is no reset on a 1996 Chrysler Sebring.There is no reset on a 1996 Chrysler Sebring.
Where is the crank sensor on a 1996 Chrysler Sebring 2.5?
It is on the top rear of the transmission bell housing.
What is wrong if a 1996 Chrysler Sebring computer reads 'cam position sensor no signal'?
There is a problem with the cam sensor or the wiring to it.
How do you replace the camshaft sensor on a Chrysler Sebring 1996 2.5l v6?
The cam sensor is part of the distributor. You have to replace the entire distributor.
Where do you find the throttle position sensor on a 1996 Chrysler Sebring?
It is on the throttle body, opposite of where the cables attach.
Where is the crankshaft position sensor in a 1996 Chrysler Sebring JX 2.5L V6?
It's in the transaxle housing.
What are the symptoms when a crank sensor is bad in a 1996 Chrysler Sebring?
The most common would be engine cranks but does not start.
Where is the camshaft sensor on a 1996 Chrysler sebring?
On a 4 cylinder it is on the end of the cylinder head. On a 6 cylinder it is part of the distributor.
How do you know if a crankshaft sensor is going bad on a 1996 Chrysler Sebring convertible?
When a crankshaft sensor is bad the engine will not run. The sensor is not usually intermittent, it is either good or bad.
What does code P1296 on 1996 Chrysler Sebring convertible mean?
Trouble code P1296 means: No 5 volts to MAP sensor
How do you reset a fuel shut off switch on a 1996 Chrysler sebring coupe?
A Chrysler Sebring does not have a reset switch.
