Disk brakes? they push in or twist in clock wise
This applies to all disk brakes. If the piston is a hollow cup, it pushes in. If the surface is flat with a line across it or a hourglass or some other figure on the surface, it screws in.
The diameter of rear door speakers for a Toyota Auris are 4 inches. However, they can be replaced with speakers that are slightly larger.
I have used a large "C" clamp, to compress the caliper flush to the face.
As far as I know, this applies to all cars regardless of manufacture. If the piston in the caliper is a hollow cup, it pushes in. If it is solid with a flat surface and some sort of design or a groove in the face it turns in to compress.
Replace the caliper and bleed the brake system.
You will need a caliper rewinding tool
How do you compress the rear brake caliper pistons to install new pads on vw polo 08 model?Read more: How_do_you_compress_the_rear_brake_caliper_pistons_to_install_new_pads_on_vw_polo_08_model
It requires a special tool to turn and compress the piston in at the same time.
You need a caliper tool and a ratchet. Caliper tool is a cube with prongs on it, a couple dollars at a parts store or online. Just turn the caliper tool and on the caliper and it will compress.
c clamp or channel locks or depress the pedal
with a large pear of channel locks,or a caliper compressor
How do you compress the rear break caliper, pistons on a 2002 Sierra ?
Most likely the piston will need to be turned not compressed