0
Let me explain a little first... I am using a Boss BCB-60 with two distortion pedals, a fuzz, a noise suppressor and a crybaby. All the signals are coming through except for my wah which is acting like a killswitch whenever I activate it. Everything is in the right place (plugged in the right order) so I can't see what is wrong, and need help!
What else can I help you with?
THE AMPS the same when two batterys are conectec in series?
Yes, the amps stay the same but the voltage doubles. If you connect in parallel the volts stay the same and the amps double.
What do you increase If you connect two twelve volt batteries in parallel?
amps
Can You Connect a AV Receiver to a MultiChannel Amp?
Yes if the frequences and amps are the same amount
Why use a guitarbass amplifier instead of going straight into the mixing board?
every guitar has a tone range. every effect pedal has a tone range. and thus, every amp has a tone range. amps can make a world of a difference in the overall tone of the guitar or bass. in the battle between solid state and tube amps, no solid state that I've heard, even comes close to the beauty of hot tubes.
How can I split a guitar signal to two amps for a more dynamic and versatile sound?
To split a guitar signal to two amps for a more dynamic sound, you can use a device called an ABY pedal. This pedal allows you to send your guitar signal to two different amplifiers simultaneously, giving you the ability to blend different tones and create a more versatile sound.
What is the line out on a fender amp?
To run a monitor speaker or to connect several amps in series to pre-amp your amp.
To construct a battery with a current of 6 amps you would connect six 1 amps cells?
You would connect them in parallel to increase the amerage. If you connect them in series it would increase the voltage. Connected in series-parallel would increase both voltage and amerage.
How much does a pedal power generator cost?
You can find one a pedal power generator.com and the price is $479 dollars. 0-40 volts,output 20 Amps,peak watt: 300 Watts. The model is PPG-B300W and there are other generators as well.
How much power do you need to connect 10 amp load?
Volts x Amps = Watts On 120 V you can connect 1200 W...although you might want to leave some room.
How do you get 4 ampere from 2 volt power supply?
if you connect a 0.5 ohm load to it, the power supply will try to push 4 amps through it. but 4 amps@ 2 volts is quite a lot, and it may not succeed.
What gauge of wire to connect electric dryer?
You need a 3 conductor #10 cable. A #10 wire is rated at 30 amps.
Can I use a 12v 18 amp battery and connect to a circuit that asks for 12v Static current 6mA Can I use resistors to lower the amps on the 12v 18amp battery or can I just connect it up?
Just connect the circuit. It will only draw the amps it needs to operate. It is just like connecting a 100 watt light bulb that draws way less than 1 amp, to a 20 amp household circuit.
