By reading the manual cocerning circuit amperage
There should be a label inside the panel that tells you how many amps it will draw. If you can't find it, contact the place you bought it or consult an electrictian.
The circuit breaker for the headlights is built into the headlight switch.
Where is the circuit breaker for power window in 1990 camry?
You can find the wiper and washer circuit breaker at most large retail stores. You can also find the circuit breaker at many local hardware stores.
Proper name is GFCI (ground fault circuit interrupter). It could be a breaker or receptacle. It's used for wet location circuits, like bathrooms, kitchens, hot tubs, outdoor
find amphere required
A circuit breaker is designed to 'break' in a circuit if a short circuit (or other malfunction) occurs. This prevents overheating (or burn-out) of the circuit wires. In older systems, you would need to find which fuse wire has fused and replace it. In a circuit breaker, once the fault has been found and corrected, the breaker is simply switched back on.
A circuit breaker does not "cause" smoke. A circuit breaker "breaks" a circuit when there is too much current, creating a hazardous condition for the wires that are connected to the circuit breaker. The circuit breaker PROTECTS you from electrical fire. Find the source of the smoke; what burned? If a circuit breaker tripped during the incident, it is usually caused by melting/burning wire insulation, either inside or outside of an appliance. If the insulation inside the walls of your house has burned/melted, it could be that the circuit breaker was too large for the wire or that the circuit breaker failed to shut off at the appropriate current load. If the circuit breaker failed, your insurance should help you. If an appliance overloaded the circuit, your insurance should help you. If someone connected an oversized circuit breaker, causing the wire to overheat, your insurance company may refuse to help you.
If you are talking about a breaker in a house panel then a 15 amp breaker would be used. It is the smallest amperage breaker that you will find in a house panel.
Replace it immediatly, the breaker is no longer within code.
You would need to change a circuits voltage if your adding a load that requires 220 when the present circuit supplies 120. If you need to do so it's pretty simple! First purchase a double pole breaker at the proper amp rating. Next find the breaker in the panel that supplies power to the circuit you wish to change to 220. Turn off the breaker and pull it out. Find the neutral for that circuit. Then double check and make sure it's the right neutral. Then check one more time. Now take the neutral and the hot wire for that circuit and connect them to the double pole breaker. install the breaker into the panel and turn it on. If you connected the right neutral you'll have 220 on that circuit. If you didn't you'll know because you'll trip the breaker.
When there is a fuse, yes it is part of a circuit. The fuse is a cheap, replaceable circuit breaker to avoid damage to the circuit components.