answersLogoWhite

0


Best Answer

get under the car and have a friend turn the key on and off...dont start the car but listen to the fuel pump it should make noise if it is clicking on...also use a test light to test the relays....could also try juicing the pump, hook up battery pack or jumper cables to wires on pump and see if it cycles

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you know if your fuel pump is bad on your 1996 Chrysler sebring?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the fuel filter located on a 2005 Chrysler Sebring sedan?

I'm the one who asked this question, I now know the answer. It is located in side the fuel tank. The 2005 sebring doesn't have an external fuel filter.


How do you know your 2008 Chrysler Sebring has enough oil?

There is a dipstick.


How do you locate it on a 2005 Chrysler sebring touring?

Need to know what it is you want to locate.


How do you know if a crankshaft sensor is going bad on a 1996 Chrysler Sebring convertible?

When a crankshaft sensor is bad the engine will not run. The sensor is not usually intermittent, it is either good or bad.


How do you change transmission filter 97 Chrysler sebring?

today I change my own in my 97 sebring, I will let you know when I finish how it went


Why won't a 1996 Chrysler Sebring shift from 2nd gear to drive?

That happens when the transmission computer detects a malfunction and sets a code. You need to have it checked with a scan tool to know possible causes.


Fuel filter location on a 2004 sebring?

There is not inline fuel filter on a 2004 Sebring. The only filter on it is the one on the fuel pump and the only way to change that is to replace the fuel pump. $175 at autozone. Ridiculous I know!!


Where can you get a pcm for a 1996 Chrysler sebring?

I found a place where you can buy PCM' for 96-06 Chrysler Sebring, Dodge Stratus & Cirrus with a lifetime warranty, programmed & updated for your VIN & mileage. I found a PCM there for my 1997 Chrysler Sebring Convertible JS which has California emissions...so a hard part to find on the East coast. I will be buying it in about 2 weeks, so I'll let you know how it goes! http://www.allcomputerresources.com/ 1-866-699-5230 ALL Computer Resources, Inc. $199 FREE Shipping


Where is the Fuel Pump Relay Switch located on a 1996 Chrysler Sebring?

I have a 96 sebring. Open the hood and to far right side of the firewall you will see three relays clipped to it. The far left relay is the one that is energized to run the fuel pump for 1-2 seconds in the on position before crankingso you have fuel pressure to start the car.(this all I know for sure) I was told that there is another relay that take over (after the motor is spinning) while the motor is running. I dont know which one that is. The start relay is the cheap one, I do know that!!!! ($13.00) I have replaced 3 on my car. Hope a little info is better than none...... Good Luck!!!!!!!


How do you know if you have a Mitsubishi motor in your 1997 Chrysler sebring convertible?

The 2.4 liter 4 cylinder is built by mistubishi


How do i know if the cv boot is bad on my 2004 Chrysler sebring convertible?

You look at it and if it is cracked and leaking grease it has failed.


What type of brake fluid does a 1996 Chrysler sebring use?

All vehicle manufacturers recommend DOT 3 Brake Fluid. Find it at your local parts store. Just ask a salesperson for brake fluid, they know what you need.