0
First remove the plastic part of the air intake and it is on the front side of the motor... there are 2 of them usually bank 1 messes up first that's on the drivers side and it helps find it if you buy the part which is only 23.99 and will stop your car from cutting off
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you change the cabin air filter on a 2003 Infiniti M45?
Its on the passenger side front right on top where you put your feet. There are 2 white twist knobs. Andd it pops out so dont be afraid to pull a little.
You programmed the fob for a 03 infiniti m45 it locks and unlocks but it wont turn inigition please help?
if the sercity light come on when you put the key in its the mobilizer i just had the same issue i had mines told to the dealer and it was fix in a week
Is it hard to put a camshaft senor on a 2005 Dodge Neon?
It's a 10 minute job if you know what you are doing... take battery out, remove wires from clip, take 4 bolts out, replace... They go out frequetly, so buy them in bulk...
How long does it take to put a camshaft on a 91 Honda civic dx?
To put the camshaft in takes a few minute. To strip down the engine to the stage where you can fit the camshaft and then rebuild it can take several hours.
How do I put a camshaft position sensor for 1996 LS400 Lexus?
where is the camshaft position sensor laocated at on a 1996 ls 400 lexus
How do you put on a fuel filter for a 1994 infiniti J30 car?
How do you change the fuel filiter on an 97 J30 infiniti and how do i know that i need to change it?
What are the thing that would not make a 1997 Buick skylark start after I put a new crankshaft senor on?
theft system
What type oil put in infiniti j30?
10w-30 or 10w-40 oil
What would make the camshaft on your 350 Chevy move in and out when you turn the distributor?
That is because of the way the gear on the distributor and camshaft is tapered. If you turn it the other way it will pull the camshaft towards the rear of the engine. That is all normal. When you put it all together it won't do that.
What is the difference between a camshaft angle sensor and a camshaft positioning sensor If there is any?
have never heard of a cam angle sensor. the cam does not change angle.it stays put in the bearings
Looking for the out put shaft senor that is located on the transfer case 96 ford explorer?
on the upper, front side of the transfer case
How do you replace the alternator belt on an infiniti J30?
Is the timing belt on a j30 infinity run the alternator
