if it is glazed ceramic tile - let it dry fully (I let mine dry for a few weeks) then CAREFULLY pop the glue off with a chisel. Hold the chisel so the flat end is up and the beveled end is on the tile and gently push the tip of the chisel into the (expanded) gorilla glue. hit the end of the chisel with the palm of your hand and the glue will pop off the ceramic.
Yes, soften it with Goof Off, then scrape it with a craft knife, blade almost parallel with tile.
Mix white vinegar in with warm water and scrub itAny floor cleaner or soap will remove the urine. Ceramic tile is not porous so it will not have been absorbed by the tile. The grout should be sealed so that shouldn't absorb it either. Just clean the floor as you normally would.
yes just prep your your tile with ardex
Yes, Pine-Sol can generally be used on ceramic tile. It is a multi-purpose cleaner that can effectively clean and disinfect ceramic tile surfaces. However, it's always a good idea to check the manufacturer's instructions or test the cleaner on a small, inconspicuous area of the tile first to ensure compatibility and avoid any potential damage.
yes
It depends on the type of ceramic adhesive. Many of them can be taken off tile with lacquer thinner on a rag.
Yes, soften it with Goof Off, then scrape it with a craft knife, blade almost parallel with tile.
A vinyl tile glue will do that -Mapei Ecobond, in Home Depot.
If the carpet glue is dense enough to affect your tile cement then you should remove it by sanding. -If it's only sparse then it won't matter.
Epoxy or silicone.
No, it wouldn't work as Gorilla Glue swells. It would be better to use vinyl tile glue or spray contact cement
Remove the adhesive.
yes
Scrape off carefully with a very sharp craft knife with blade held almost parallel to the floor.
Any epoxy or LePage Extreme or PL200 would work for that.
Yes you can if you first rough up the ceramic by sanding it. Use a vinyl mastic like Mapei Unibond.
It is best to remove the vinyl tile. If it is not on cement and is on wood you can install cement backer board. Be sure to put thin set under the board. If you spend the money and time to install ceramic tile and the vinyl tile comes loose all that $ is down the drain What is the best tile cement to use and this cement tile can be installed on vinyl tile and install ceramic tile on it