Under the hood right above the head lamp are 2 torx screws - 1 on each side. Remove each screw then pull the entire headlamp assembly out. Twist and pull the bulb sockets to remove them.
You have to remove the fuel tank.
When replacing the alternator on a 2000 Chrysler Sebring convertible begin by removing the belt. Next, remove the wiring. Lastly, remove the retaining bolts. Reverse the process to install the new alternator.
Remove the positive battery cable from your 2001 Chrysler Sebring battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
It is behind the rear seat. You have to remove the seat to access.
It is behind the rear seat. You remove the rear seat to access.
It is between the rear seat back and the trunk. You have to remove the rear seat to access.
The shift solenoid B for a 1997 Chrysler Convertible is located inside the transmission. The speed sensor has to be removed to access the bolts to remove the cover over this shift solenoid.
It is located in front of the left front wheel, inside the fender. You have to remove the wheel and fender liner to access.
It is located behind the rear seats. Once you remove them you will see the pumps and lines. There are several youtube vids on how to remove and replace it.
The thermostat for a 2004 Sebring Convertable is in under the water outlet for the BOTTOM radiator hose. This is behind the alternator which will have to be removed, after you remove the belts. Plan on an afternoon of work. Hope this helps.
it is located in the front drivers side wheel well. you need to remove a few screws to get to it.
I'm assuming you have a convertible since from what I've read, the sedan bulb replacement is very straightforward. To replace the bulb in a convertible you need to remove the headlight assembly by removing 2 bolts, one near each end of the assembly. These are (I believe) 8mm bolts so don't go removing the larger ones. Once the bolts are out you can remove the assembly. Remove retaining ring, pull bulb assembly out and unplug the bulb. Reverse directions for re-installation.