I'm going to copy/paste the text from the factory service manual (which you can download from Toyota for about $10). The text may refer to pictures. You don't have to be a puzzle master to figure the procedure out without them though. Essentially you simply lift the rear cushion in front like you would on almost any sedan then pull forward and remove the seat. The seat back is secured by two bolts on the bottom that you'll see when you remove the bottom cushion. Remove the headrests (2 bolts) and assorted clips.
The 'by the book' instructions:
REMOVAL
HINT:
• The installation procedures are the removal procedures in
reverse order. However, only installation procedures
requiring additional information are included.
• A bolt without a torque specification is shown in the
standard bolt chart (See page SS-2).
1. REMOVE REAR SEAT CUSHION ASSEMBLY
(a) Pull up the 2 front portions of the seat cushion, then
remove it.
NOTICE:
The cushion frame deforms easily. To avoid
deforming the seat cushion, place your hands
near the hook as shown in the illustration, and
then pull up on the seat cushion. Do the same
for the other hook.
2. REMOVE REAR SEAT HEADREST PLATE COVER
(a) Using a screwdriver, disengage the 4 claws and
remove the plate cover.
HINT:
Tape the screwdriver tip before use.
3. REMOVE REAR SEAT HEADREST PLATE
(a) Remove the 2 nuts.
(b) Disengage the 6 claws and 2 clips. Then remove
the plate.
4. REMOVE REAR SEAT HEADREST ASSEMBLY
5. REMOVE REAR SEAT SHOULDER BELT COVER LH
(a) Using a screwdriver, disengage the claw and turn
over the cover.
HINT:
Tape the screwdriver tip before use.
(b) Remove the screw.
(c) Using a screwdriver, disengage the clip and claw.
Then remove the belt cover.
HINT:
Tape the screwdriver tip before use.
6. REMOVE REAR SEAT SHOULDER BELT COVER RH
HINT:
Use the same procedures described for the LH side.
7. REMOVE REAR SEATBACK ASSEMBLY
(a) Remove the 2 bolts and 2 rear seat outer belt
anchors.
(b) Remove the 2 bolts.
(c) Remove the seatback in the direction indicated by the arrow in the illustration.
8. REMOVE REAR SEATBACK WIRE
(a) Remove the 2 bolts and seatback wire.
No, the key must be on for the display to show.
Yes. The generation I Solara was assembled in Cambridge, Ontario Canada. The generation II Solara (2004 to present) has been assembled at Toyota Motor Manufacturing in Georgetown, Kentucky.
Group 35 Battery Size
what do a tune up consists of? I have a 2005 toyota solara se
21mm
2005 Toyota tacoma how to remove the brake rotor
how do you remove the center console on a 2005 toyota camry
The 2005 Toyota Camry has a sporty look that previous models did not. Also, it is the first generation wide body Camry. This car is also called Toyota Solara.
How do i remove a stuck Cd from my 2005 Toyota Highlander? The CDs will not eject.
You need 5W-30. The oil viscosity recommendation should be marked on your oil cap and in the owner's manual. Cheers
Your best source is a Toyota dealership. A possible alternative 'might' be an auto recycling yard but removing an ignition harness on a modern car intact could be difficult.
Cool bra