1. First turn the ignition off
2. Press and hold the trip odometer button WHILE turning the key to position 1
3. Keep the button depressed about 5 seconds until you see "oil service" or "inspection" with "reset" or "re" in the display then let go
4. Press the button again and hold for approximately 5 seconds until "reset" or "re" flashes
5. While the display is flashing, briefly press the button again to reset the service interval. After the display has shown the new interval you should see "END SIA" for about 2 seconds
*Note that if the "Reset" or "Re" does not flash, then you have not met the minimum consumption even and cannotreset
This procedure has been tested on the E46 3 Series
Hope I helped :)
You'll need to use a scan tool or other OBDII software to reset your service lights.
The oil change light on a 2006 BMW 330i is reset by turning the key, pressing the trip button, and then the DC button on the turn indicator. The left scroll button is then used to select the oil light and the DC button held until it clears.
After replacing pads and sensors, turn the ignition key on and leave on for approximately 2 minutes. This resets the brake pad wear warning light.
There is no oil dipstick in a 2006 330i.
no alarm installed
there is no dipstick
For your 2006 BMW 330I: Wheel Stud Torque 72-87 Foot pounds (Final torque)
I found that urinating on the passenger seat works well. You can also try inserting your phallus into the cigarette lighter to cause a short.
If your 330i is a 2006 model or newer, it does not have an oil dipstick. Otherwise, check the oil dipstick for oil level.
i have a circular light on with an exclamation mark inside i have a 2006 330i bmw what does that mean it pops on and then goes off
The 2006 330i e90 tank can contain up to 6.8 quarts or 6.5 liters of oil. An oil change for this car can be done at home; however, it is advised it is done by a professional due to the difficulty.
The tire light can come on for a number of reasons. Low tire pressure, a flat tire, or in my case a couple days ago, I got the tires rotated. Confirm the tire pressure on each tire, which is usually a sticker on the driver inside door frame (my car is 29#'s on the front and 36#'s on the rear tires). You can reset the warning light after confirming there is no obvious problem with the tire condition and pressure. Your owners manual will have the information for your model and year on how to reset certain error codes or call BMW service for some help. I have a 330i and all you do is push the (2) on the short column (by the blinker), then keep pressing the number (1) button until the tire symbol appears, then push and hold the number (2) button for 5 seconds until a little check mark appears, then drive away.