On some Chrysler radios there are two round holes on the display panel of the radio with a letter h and m for hours and minutes. just take pen point and push into these holes to set the time.
It is under the steering wheel.
It is the electrical connection under the steering wheel that allows for rotation.
In my 1995 Metro there is no clock, other than the one that is in the stereo. If the stereo is bad, just replace it. You will need a new stereo, a wiring harness if you don't want to hack up the old factory harness, and a install kit to make the stereo fit in the hole if the old stereo is factory. Then just follow instructions included with these parts.
Turn the key to accy' and turn the radio on. Push DISPLAY button until the clock time shows on the radio display. Look to the top right of the radio and you will see 2 small holes there that are marked "H" and "M". Using a paper clip or tip of a ball point pen, push the "H" button until the desired hour is reached, repeat doing the same for "M" for the minutes. You will notice there are no separate AM or PM settings for the clock.
Clock radios can come in many varied types. It is not necessary for every clock radio to come equipped with stereo. If so desired, you can also get an AM/FM stereo with a clock radio
Get a toothpick and beside the clock there will be two indented buttons, one with a H other M, just take your toothpick and push in the button.
Use the clock on the aftermarket stereo that you should buy. My clock on my 92 always gets off so i just use the clock on my stereo.
If you clock does not work in your Peugeot 206 when the stereo is plugged in, check the clock fuse. You should also ensure you do not have a wiring problem.
How do I change the clock setting on a 1997 Chevy Lumina with a CD stereo system?
You need to switch off the stereo and then you can use the buttons next to the clock to change the time. this also changes the time on the stereo.
power from the battery
For me the reason the clock and stereo were resetting was because they were losing all power from the battery. The battery was dead. maybe your cables need to be cleaned or there is a loose connection.