How do you turn off the oil change message in a 2008 Chrysler Sebring?
Turn key on, engine off, press gas pedal to the floor three times. cycle key. light should be reset.
4 people found this useful
You will need wrenches and possibly an oil filter socket or large channel locks, and of course a drain pan. Locate the oil drain plug in the oild pan and remove it. (hot oil w…ill come out into the drain pan at this point ) when it is finished draining (dripping) reinstall drain plug snugly. Locate and remove the filter by using either the filter wrench or the large channel locks. (make sure the old rubber ring gasket on the oil filter is in the filter still and not stuck to the engine block mating surface) install the new filter hand tight only. Add 4 qts of engine oil to the engine through the cap marked for engine oil. Start the vehicle check for leaks. Shut off the engine and check the dispstick and add oil (if needed) to bring the engine oil level up to the full mark on the stick. (checking oil must be done on a level surface) reinstall cap...Done.
Key on, engine off. Press the gas pedal to the floor three times inten seconds.
You remove the screws that hold it in place.
That light indicates poor oil pressure. Not, low oil necessarily. You may have a leaky gasket.
To reset the oil warning light on a 2008 Chrysler Sebring, turn onthe ignition without starting the engine. Slowly push theaccelerator down three times. Next, turn the ignitio…n to the lockposition and the warning light should be gone.
It will depend on your driving habits, but between 3000 and 5000miles.
It is on the bottom of the engine or transmission.
It is on the bottom rear of the oil pan.
Does a 2000 Chrysler sebring convertible have an oil sensor that turns the car off automatically if it senses that the oil is empty?
Why does your oil light keeps coming on in your Chrysler sebring 2004 i have changed the oil pump and it comes on when I stop and go off when i accelerate?
The first thing to check is what is the pressure at idle with theengine warm. You will need to instal a manual gauge. If it is above15 psi, it is an electrical/sensor issue. I…f it is below 15, it isan internal engine issue.
Key on engine off, press gas pedal to the floor three times, cycle key off and back on.
Key on, engine off. Press the gas pedal to the floor three times. Cycle key off and on.
There is a dipstick.
No, only reset till next time. No, only reset till next time.
The 3.5L needs 10W30. All other engines use 5W20. The 3.5L needs 10W30. All other engines use 5W20.
Push the flasher button. It will have a triangle symbol on it. Push the flasher button. It will have a triangle symbol on it.