i dont know why are u aksin me 4
616 yards
It depends on the size of the roll,
1 yard
Area of roll = 72.835 yd x 255 yd = 18,572.925 yd2 = 15,529.33 m2
This varies greatly. Usually more then 100 sq yards, but less then 200 sq yards.
there are 3 feet in a yard so 120 feet equals 40 yards.
300 square feet.
45"
36 inches x 20 yards = 720 inches.
There are 9 square ft in a square yard. So if you have 1800 square feet of carpet on this roll you only need to divide it by 9. So, the roll of carpet you are looking at is 200 yards.
Place two rolls of twine into the twine chamber, pull the end of the twine from the center of the rolls. Thread the twine from each roll through the loops in the lid of the twine chamber. Each twine should go through the loop on the side of the lid that the roll of twine sits on. The left side through the left loop, the twine on the right side through the right side loop. Run the twine through the two tubes on the left side of the twine chamber. The again, the left through the left side, the right through the right side. Close the lid to the twine chamber. Run the ends of the twine through the porcelian electric insulator fastened to the needle carriage, then the ends of the twine through the eyes of the needles. Again, the twine from the left side through the left needle eye, the end of the twine from the right side through the eye of the right needle. Pull the ends back to the protective pipes surrounding the needles and tie the ends to the pipe. Raise the bale trip lever on the drivers side of the bale chamber so it will trip shortly after you power the baler. You will need a small amount of hay going through the chamber to do this. When the bale trip lever trips, the needles will come up and the knotters will grab the twine and hold it. You are now ready to bale.
grave yards, rock and roll is dead