Want this question answered?
5 grams
about the size of a little brother
Use the screw driver to remove the outer casing of your measuring tape. Cut off the metal end of the tape and then cut a piece that is 6 inches long. You'll need a 6-inch piece for each slap bracelet that you want to make. Use the scissors to round the edges of the piece of measuring tape.
You have to take the plastic piece off. Then pull the bulbs straight out. They are hard to get to, so the best way I have found is to get a small piece of electrical tape, about a inch long. Wrap the tape around the bulb. Make sure to get as much of the sticky part on the bulb as you can. Then pull the bulb out with the tape.
Use the screw driver to remove the outer casing of your measuring tape. Cut off the metal end of the tape and then cut a piece that is 6 inches long. You'll need a 6-inch piece for each slap bracelet that you want to make. Use the scissors to round the edges of the piece of measuring tape.
were is 15/16" of an inch on the measure tape
Roll it out, tape the edges to subfloor. Tape each subsequent piece to previous piece.
About 300 grams (could be a little less or more due to tape length e.g 1 hour, 3 hour,s)
A piece of tape on a rubber balloon acts as a reinforcement so the rubber does not rip when poked by a needle in the tape.
The standard width of tape - it measures one inch across. Other common sizes are 1/2" (12mm) or 2" (50mm)
you can buy a special tape that you wrap around their body and it tells you their rough weight
firstly neddle should be needle 2nd it is because the tape is like a kind of shield