Yes, you can't use any breakers that have not been engineered for the application.
Code states that there must be a clear 3 foot space in front of the panel.
In the CEC there is no definition for a load center. In layman terms a load center is; A distribution panel that does not have a disconnect breaker in the same enclosure. A distribution panel that does have a disconnect breaker within the enclosure is called a combination panel.
It depends on your local building code.
Yes.Additional InformationBreakers and fuses protect the wires to prevent fire. The 100 Amp breaker in the meter base (main) protects the wire from the meter base to the breaker panel. The 50 Amp breaker in the breaker panel protects the wire from the breaker panel to the outlet. Sometimes the 100 amp main breaker is located in the panel.If you are asking "Can you use two 50 amp breakers for the main breakers with a 100 amp service, then yes you can. The National Electrical Code allows you to use up to 6 breakers as the main overcurrent protection.
No, it is still live even when the switch is open...
It can be right next to the panel if you want. There is nothing in the code that says otherwise.
Code states that there must be a clear 3 foot space in front of the panel.
Yes, the code requires a complete dead front so that no access can be made to the bare distribution bus behind the panel face.
In the CEC there is no definition for a load center. In layman terms a load center is; A distribution panel that does not have a disconnect breaker in the same enclosure. A distribution panel that does have a disconnect breaker within the enclosure is called a combination panel.
I would approach the city council and ask them to either direct enforcement or modify the city code to match the reality of code enforcement.
It depends on your local building code.
Yes.Additional InformationBreakers and fuses protect the wires to prevent fire. The 100 Amp breaker in the meter base (main) protects the wire from the meter base to the breaker panel. The 50 Amp breaker in the breaker panel protects the wire from the breaker panel to the outlet. Sometimes the 100 amp main breaker is located in the panel.If you are asking "Can you use two 50 amp breakers for the main breakers with a 100 amp service, then yes you can. The National Electrical Code allows you to use up to 6 breakers as the main overcurrent protection.
Not exactly sure what your question is and you need to make sure you are in compliance with electrical code for your jurisdiction. But, generally speaking you install a large breaker (let's say 100A 2 pole breaker to power the sub panel) just as you would install any other breaker in the presently used (hot) panel, and the proper sized cable then goes from old to new and terminates on the main lugs of the new panel. Ground and neutral are usually isolated from each other in the sub panel but depends on other factors as to location of the sub panel, etc.
No, it is still live even when the switch is open...
The storm-breaker is not a code item, you but it with SC
Before you can modify an accounting code view, what needs to be in place? Answer this question…
Yes, you can be arrested for a violation of a Municipal code in California.