The level of current you are most likely to be in danger of death depends on the path of current flow through your body, and on the frequency of that current.
With sufficient current, there is always the danger of burns, usually on the surface of the skin, which is particularly an issue with high voltage.
The most sensitive organ is the heart. Interestingly, frequency is a big factor. If you were to apply DC, it would simply stop and then start, assuming you did not apply enough to cause internal damage. If you were to apply AC, with the right frequency, and with just the right current, you can do irreversible damage to the heart's pacemaker, the sino-atrial node. The heart would then enter irreversible ventricular fibrillation, and you would die.
It turns out that the most dangerous current is about 1 ma, at 60 hz, applied directly across the heart. Depending on external skin resistance, this translates to around 120 AC, 60 hz, applied from hand to hand, with the current path through the chest.
According to the current edition of the IEE Wiring Regulations (UK), for a.c., 'low voltage' is defined as being between 50V and 1000 V (between conductors) or between 50 V and 600 V to earth (ground). So, yes, low voltage can most definitely kill!
400 to 600 volts can kill you
Current shall increase while you apply 415V for operating it and will decrease the rpm to a much low level.
It just transmits the level of the fluid into electric signal to level indicator and this level indicator will show current level of fluid.The whole setup is used for level measurement. A Level Transmitter is simply an instrument that provides continuous level measurement. Level transmitters can be used to determine the level of a given liquid or bulk-solid at any given time. This is different to a level switch which only alarms when the level of material (liquid or bulk-solid) reaches a predetermined level.
To cause a Shockley diode to stop conducting, reduce the current going through it to a level below its low-current dropoutthreshold.
...of what? to a house, to a breaker (to lower fault current level?), to an amplifier circuit?
This describes what is known as the 'fault level' at a particular point in an electricity transmission or distribution system, expressed in megavolt amperes, enabling the theoretical value of fault current to be calculated at that point in the system, in order to ensure that the relevant switchgear is capable of interrupting that level of fault current.
current level aspired level
Danger level of uric acid.
That will depend on the level of the crime. If there was a death involved, there is very likely no limit.
The danger zone on Mt. Everest is above 20,000 feet above sea level.
Current as of when?
because of the physical strength required, danger level and, level of high skill
The level is higher than most people.
WET WATERS is not level 4
There are many different predictions about sea level rise, but the most likely sea level rise by 2100 is between 80cm and 1 metre (2.5 to 3 feet).
Current Internet Threat Level. The threat level is at AlertCon 1.https://gtoc.iss.net/ - Today's Internet Threat Level: GREENisc.sans.org/
Packing Group I (PG I) is the greatest danger; Packing Group III (PG III) is the least.
Detention Block AA 23. I am not sure what level in the Death Star it was exactly. The Death Star level is Level 5.