0
Place the steps for exiting a contaminated zone in the correct order assume the zone you are about to enter is in mopp 2?
Wiki User
∙ 14y ago
1 - Check your vehicle and its cargo for contamination
2 - Perform decontamination on the vehicle or cargo if necessary
3 - mark contaminated assets with CBRN marking signs
4 - Perform protective glove and boot contamination
5 - Remove your hood, protective mask, and gloves so you are at MOPP 2
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Is the sentence-- you saw your uncle and aunt come out--correct?
Yes, the sentence "you saw your uncle and aunt come out" is grammatically correct. It describes the action of seeing both your uncle and aunt exiting from a place.
What should you do with used components of an M295 Equipment Decontamination Kit?
Place them in a contaminated waste disposal container.
Place the steps for entering a contaminated area in the correct order assume you are in mopp 2 and the zone you are entering is a mopp 4?
1- Replace or refill your individual canteens. 2- Assume MOPP 4 3- Check your supply of decontamination kits, antidotes, and detection paper
What should you do when a car is entering and another car is exiting at the same place at the interstate?
Get on the brake ;)
What is the man with the red eyes is willing to assume for the people of his planet?
If this is related to the book "Wrinkle in Time", then please state so and/or place this question in the correct category.
What are the used components of an m295?
place them in a contaminated waste disposal container
Name a place where aquifers are most likely to be contaminated?
An aquifer is most likely to be contaminated at its recharge zones. These are the areas in which water is directly infiltrated into the aquifer.
What should you do with used compinents of an m295?
place them in a contaminated waste disposal container.
How can streaked plates become contaminated?
If it is left open on the bench it can be contaminated by bacteria in tyhe air, e.g. micrococci. If the loop was not flamed adequately before innoculation this can also cause contamination. and also if the medium used was not sterile in the first place the plate will be contaminated.
If a normal cell divides you can assume what?
if a normal cell divides you can assume that
Why is it important to place the developing solvent in a clean dry beaker?
So it doesn't get contaminated with dirt.
What should you do with used components of an M291 Skin Decontamination Kit?
Place them in a contaminated waste disposal container
