answersLogoWhite

0


Best Answer

how will you start 3phase inuction motor using star delta stater

User Avatar

Wiki User

11y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

11y ago

The motor terminal box should have six wires coming out of it.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Star delta starter for 3 phase induction motor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Are contactor points and bimetallic strip connected to the star delta starter of 3 phase induction motor?

yes


Theory for brake test on three phase induction motor?

why three phase induction motor is delta connected


Do you need starter for 0.5HP three phase induction motor?

You never need a starter for a three-phase motor.


What device may be wired into the starting circuit of a motor to improve the starting torque?

I assume a 3 phase, AC induction motor. A star delta starter or a soft starter can be used. A soft starter is better compared to a star delta starter, but it is more expensive.


What are the various methods of starting a 3 phase induction motor?

by motor starter


How do you start single phase induction motor?

capacitive start motors start by themselves however a normal single phase induction motor requires a starter motor to 'kick-start' the motor into action.


Is a starter is necessary for three phase induction motor?

A starter is unnecessary because the stator produces a rotating magnetic field.


Why are no starting components needed on three-phase motors?

Yes, by using a DOL Starter, which gives a controlled "soft-start" for the motor even though it is always connected in delta configuration.In this type of starting a 3-phase motor, full voltage is applied to the motor through relays and contactors. Its is the most common type of 3-phase motor starter used.DOL means Direct On-Line starter.


Is 3 phase induction motor is self starting?

Yes, that is one of the major advantages of a three-phase induction motor.


Why each phase no load power factor of 3 phase induction motor is not same?

That indicates a fault in the induction motor.


How do star and delta configured three phase induction motors perform differently?

Star Delta starter control wiring ensures that initially the Motor winding is connected in Star and after set timer (few seconds) the winding gets connected in Delta automatically. There three power contactors and timers to make it happen.


How can you include phase failure relay in your star delta motor starter circuit?

The star delta motor starter circuit has to have a control voltage to energize the motor magnetic contractors. A phase failure relay monitors all three phases of the incoming supply lines. The phase failure relay also has auxiliary contacts on it. There are usually two sets of "C" form contacts. The control voltage for the starter circuit must be connected across the normally open (N.O.) contacts of one of these two sets. When the phase monitor is energized these N.O. contacts close supplying the control voltage to the circuitry of the star delta starters. If there is a phase interruption, phase reversal or phase loss, the phase failure relay will de-energize and the N.O. contacts will go back to their de-energized state. If the star delta motor starter is in use at the time, its control circuitry voltage will be lost and the delta motor magnetic contactor will open. The opening of this contactor will disconnect the motor from the failed three phase supply.