What would you like to do?

What causes the horn to go off when there is nobody pressing the horn pad on a 2006 sebring?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

probably a short in the wires somewhere

More than likely, it is a short located in the horn pad inside steering wheel unit.

Probable failed horn pad/ air bag cover
2 people found this useful
Thanks for the feedback!

How can you disable the horn going off every time I press the remore lock on my 2007 Dodge Ram 1500?

I have a 2005 Ram 3500 and in the owners manual under keyless entry it tells how to disable the horn honks. On my truck (and I did do it) the procedure is: 1. Sit in driver

How do you stop 2008 sebring horn chirp?

You can download the manual for you car at http://www.chrysler.com/en/owners/manuals/. To disable the horn chip, follow the instructions on page 24 of your manual:. Press th

How can you disconect the horn on 1996 Chrysler sebring?

Open driver door. Remove plastic fuse panel at end of dash... You have to rotate it counter-clockwise, then pull. Find the 20a fuse and simply pull out. No need to disconnect

1998 Cadillac Deville my factory alarm does not work The doors will lock and the horn honks when you press key pad But it won't go off if the car is tampered with What do I need to check?

1.disconnect positive battery cable wait About 5 sec 2.then reconnect battery( p+cable+) car alarm will honk continuious . insert key in driver door turn right then left and r

Where is the horn on a 96 Chrysler sebring convertible?

If your facing the front of the car, they are mounted on the front, over near the left hand side. It is jambed packed full, so you have to look close----they use a dual horn,

How can you disable the horn going off every time I press the remote lock on my 2011 Dodge Caravan?

Straight from the Owners Manual of a 2011 Dodge Caravan • For vehicles not equipped with the EVIC, perform the following steps: 1. Perform this operation while standing