Tolerance in size is the allowable amount of change in dimension. For example, you want to fabricate a shaft that is 2 cm in diameter plus or minus 2 millimeters. The 2 millimeters is the tolerance. Tolerance in position is the allowable amount of change in position. For example, you need to drill a hole in a wall and you drew a point in the place you want to drill, you are allowed to move as far as 2 millimeters from that hole to receive satisfactory results, this is a tolerance of 2 millimeters in position
Engineering measurement tolerances are the permissible limits of variation in measurements. Example a piece of steel 25mm square where it would be allowed to be +.001mm or -.001mm on this size. The plus or minus is the tolerance
Need more info - what is it for? What is the size of the pipe and the pressure differences you are trying to get?
The screw adjusts the size of the gap between the spring attached to the armature and the circuit wiring. This gap has to be just the right size for the make-break action to work properly. Wear and tear and vibrations can alter the gap, or conceivably even large temperature differences, so an easy way to put it back is necessary.
memcpy()
A single memory position variable can store only one value of its type. An array can store n number of values, where n is the size of the array.
on the basis of nominal diameter with tolerances is called nominal size, while required size is called basic size
Common differences are size and color.
size
size and value
Size and material its made of
The differences is the size.
The only obvious differences between male and female crocodilians are their size differences :)
There are no discernible differences between newborn koalas. At birth, they are all pink, hairless and about the size of a bean.
Yes, a men's b-ball is bigger, its a size 7, women's is a size 6
The size, atmosphere, composition, and crust activity.
Engineering measurement tolerances are the permissible limits of variation in measurements. Example a piece of steel 25mm square where it would be allowed to be +.001mm or -.001mm on this size. The plus or minus is the tolerance
probably their size and how much they eat. It depends from animal to animal but those are probably the biggest differences.