What does the automatic shutdown relay control on the 1999 Chrysler sebring convertible control or shutdown?
It shuts down the voltage to the primary coil on the distributor, power to fuel injectors, and fuel pump also.
5 people found this useful
Answer . \neveryone should have a manual for their vehicle, and the library should have a professional shop manual available in the REFERENCE section...make copies of the …right sections...good luck :)
The bcm is attached to the fuse box. You will have to remove the dash by taking out the screws around the radio and on the left side of the dash. You'll have to remove the das…h silencer (above the driver's legs) as well. Unplug everything from the fuse box, then remove the three screws holding the fuse box in place. Pull the fuse box straight down to remove it. Unplug the bcm from the fuse box and remove the screws holding them together. Now you've got your part number and can look for a new bcm. (I had a hard time figuring out how to do this when the gauges in my '99 Sebring convertible quit working. It's pretty easy to remove and saves a lot of money when you don't have to take your car to a dealer. Good luck!)
Relays are located behind the battery against the firewall and you do have two under the glove box ,pop it out they are on the right.
There is no such part.
in my 2001 4L jeep grand Cherokee the automatic shut down relay is located in the power distribution panel that is mounted between the fender and the battery. if it is labeled… like mine it should be number 38 marked asd.
It controls all functions of the transmission.
It is inside the under hood fuse box.
Left side under hood. Under windshield. Three relays attached to fire wall. ASD is the middle one.
I have a turn signal light that keeps flashing regardless of the control arm position. I think that the problem is in the turn signal control relay but I don't know where it i…s located. I did find the 3 prong relay located behind the center console but this is not the problem because I replaced it and have the same problem.
In PDC, two large relays on the B side, closest to the fender. One is the fan relay, one is the ASD relay. It may be labeled "engine relay"
You do not have to reset the asd relay. It is controlled by the engine computer automatically.
It is under the dash on the driver side. It is on the backside ofthe dash fuse panel.
The PCM, engine computer, controls the fuel system.
It is abbreviated ASD
The alternator does the charging and it is controlled by the engine computer. The alternator does the charging and it is controlled by the engine computer.
Transmission fluid is added through the dipstick tube under the hood.