Density can be found by the formula ρ=m/V
where
ρ=density (kg/m3 or g/cm3)
m=mass (kg or g)
V=volume (m3 or cm3)
To find the density of iron, you must first know the mass of iron at a certain volume.
You can do this by using laboratory apparatus such as a measuring cylinder and/or a displacement can to find the volume of a piece of iron. Then using an electronic balance, find the mass of the same piece of iron.
The density of iron at room temperature is 7.874 g/cm3.
i think that it depends..
7860 kg/m^3
j
Iron filings may be pure elemental iron, it depends on the source of the iron.
pure substance
Fine iron filings
If they are iron filings, you can use the property of magnetism to remove the iron filings using a magnet. You will need to rinse the iron filings with water after you remove them with the magnet in order to completely remove the sawdust from them.
When sufficiently heated, iron filings and sulfur react to produce a compound, iron (II) sulfide.
Copper filings are not attracted to a magnet, as iron filings are.
The density of pure aluminum is 2.7.Filings have a packing ratio of roughly 0.6 so the density of the filings is about 1.6. this of course depends greatly on the size and shape of the filings.
Iron filings may be pure elemental iron, it depends on the source of the iron.
The density of iron is 7,874 kg/m3 or 7.874 g/cm3. The density of iron filing is somewhat lower depending upon how fine the filings are, but I guess more than 4000 kg/m3 or 4.0 g/cm3. The SI standard of density is measured in kg/m3. The density of a material is defined as its mass per unit volume. The density of iron does not change with the size of the sample. A bucket full of iron filings will have a lower density than the block because there will be air between the individual filings. The density of a deep pile of filings will be greater than a thin pile because the weight of the filings above compacts the filings below by pushing out some of the air. However, the density of each individual piece will still be the same as for the whole block.
pure substance
magnetic separation.
iron
Sulfur and iron filings together are a mixture.
Fine iron filings
Pure iron filings will be attracted to a magnet; but pieces of iron carbonate will not.
separate iron filings AND ash from water by filtration or evaporation then, if required, separate iron filings from ash by using a magnetic field,
If they are iron filings, you can use the property of magnetism to remove the iron filings using a magnet. You will need to rinse the iron filings with water after you remove them with the magnet in order to completely remove the sawdust from them.