0
P=VI
here P=8000 Watts
v=220 V
I=8000/220
= 37 A
so you should use 37A Breaker
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What size breaker should be used for a dryer in Canada?
Minimally 30 AMPS
What is breaker size for 240 volt 9 KW?
The formula you are looking for is I = W/E.
What size breaker goes with a 15kw heat strip?
60
How many 250-watt 240 VAC HPS fixtures can be installedon a house with a twenty-amp breaker?
15, but I wonder if your information is correct. The breaker size doesn't seem to be right and a 240v circuit in a house uses a 2 pole breaker.
What is the cable size for a 3KW motor 350 meter run for cable 240v?
Assuming being fed by c32 breaker for start load minimum cable size SWA is 70mm which will go to 456 meters
How do you run dedicated 240V lines for power tools?
Answer for USA, Canada and countries running a 60 Hertz supply service.One 240 volt receptacle fed from a two pole breaker from the distribution panel. The size of the breaker is determined by the load current and the wire sized accordingly.
When installing a circuit breaker do you size the breaker to correct wire size or the device its controlling?
When installing a circuit breaker, you size the breaker based on the wire size. The breaker should be matched to the ampacity of the wire to ensure proper protection against overloads and short circuits. The device being controlled by the breaker is not a determining factor in sizing the breaker.
What is the standard to select circuit breaker?
Add up your amps to calculate your breaker size. Add up your loads (amps), divide by 0.8, and choose that size breaker. If that number does not correspond to a standard size breaker you go to the next higher standard size breaker.
What size room will a 12000 btu heat pump heat and cool?
usually around 400sq. ft room give or take
What size awg do you need to install a 240v rec on a 50a breaker?
#8. It is better to error on the next large size. # 8 THHN 90 degree wire is rated at 45 amps. If there is a possibility that the breaker is connected to a 50 amp load the wire will be undersized. A #6 wire is rated at 65 amps. For continuous use, a load factor of 80% has to be applied. 65 x .8 = 52 amps. The only time the conductor can be smaller than the breaker size is on a motor feeder. Then the breaker is sized at 250% of the nameplate full load amps (FLA) rating of the motor. This is to allow the motor's starting current, which is about 300% FLA, to not trip the breaker on start up.
What size breaker can you use on a 7500watt generator?
Depends on the wire size you are using. If the generator breaker is a 30 amp then install a 30 amp breaker.
What size breaker does it take to run a outdoor well?
Normally AWG #10 wire on a 30 amp breaker but it really depends on the size of the pump. The pump manufacture will specify the size wire and size breaker needed.
