0
It is the middle cylinder on the rear head.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Is there a fuel reset on a 1997 Chrysler Sebring JXI If so where is it located?
A Chrysler Sebring does not have a reset switch.
Where is the ecm located in a 2000 Chrysler sebring jxi?
The PCM is located in the actual engine bay on a 2000 Chrysler Sebring. It is mounted vertically next to the battery tray.
Where is the starter located on a 1997 Chrysler Sebring Convertible JXI 2.5L 6 cylinder?
Look for you oil filter, it is right next to it, toward the driver side
Where is the coil located on a 1996 Chrysler Sebring convertible jxi?
It is built inside the distributor on the 2.5L.
Where is the inertia cutoff switch located on a 1996 Chrysler sebring jxi conv?
Chrysler vehicles are not equipped with an inertia switch.
Where is the ignition coil located on a 2000 Chrysler Sebring jxi?
The coil on a 2.5L is built inside the distributor.
Where is the thermostat located on a 1996 Chrysler Sebring JXi?
4 cylinder it is under the housing where the upper radiator hose hooks to the engine. 6 cylinder it is under the housing where the lower radiator hose hooks to the engine.
Where is the crankshaft sensor located on a 2000 Chrysler Sebring Convertible jxi?
On the 2.5L it is on the top rear of the bell housing.
Where is the transmission fluid reservoir on 1999 Chrysler sebring convertible jxi located?
The oil pan on the bottom is the fluid reservoir.
Where is the fuel pump on a 1998 Chrysler Sebring Jxi?
It is in the fuel tank.
What is the oil capacity for 1997 Chrysler Sebring jxi?
4.5 quarts
Is the 2000 Chrysler sebring jxi front wheel drive?
Yes.
