cold start switch on the side of or on top of the throttle body.
Hey tom its a 1990 pontiact transport van and it starts out fine and as soon as the vehicle warms up it will stall it will start back up but when you put it in gear from park it stall again until cool?
crank sensor in 2000 dodge neon fails. car starts to stall while operating. idols with no problem, when in operation starts to stall again and again until will not start again.
push the throttle to the floor after a couple of minutes and crank until it clears and starts
a stall will not engage trans until a minimum rpm is reach depending on rpm range of the stall converter
Clean the throttle body. If that doesn work, replace the Idle Air Control (Valve), which is located on the throttle body.
You have to hold up until you are in the circle, then hold left until the battle starts.
The first generation of Escort was released in 198l. It was meant to replace the Ford Pinto. The 2nd generation of Escorts were released in 1991. The third generation and last generation of Escorts were released in 2007 and lasted until 2002.
First, movies cast. Then after a week, they start filming.
The coil pack is bad. Replace it. They'll quit working when they get warm.
The first railway started in India in 1853 from Bombay to Thane. They were not nationalized into one unit until 1951.
Initial setting: Close needle valve (rotate clockwise) until just seated (DO NOT FORCE) and then open (turn counterclockwise) 1-1/4 to 1-1/2 turns. Start engine and let it warm up (about 5 minutes). Fine tune: After engine has warmed up, slowly close needle valve until engine starts to stall for lack of fuel, then slowly open needle valve until engines starts to stall from flooding. Set the needle valve at midpoint between the two. If the engine starts to sputter while in service, open needle valve 1/8 to 1/4 turn for a slightly richer mixture. How do you adjust a float on a Tecumseh carb?
Fall Starts in September and runs all the way through until December..