No. As long as the voltage specs match. The load will only draw the current it needs to operate.
If the current specs were flipped, 3A adapter on a 5A unit, this would cause problems. The unit will try to draw the 5A it's designed for and smoke the adapter.
No one. A horse power is an Imperial measurement unit, not an SI unit and so a metre would not have featured!No one. A horse power is an Imperial measurement unit, not an SI unit and so a metre would not have featured!No one. A horse power is an Imperial measurement unit, not an SI unit and so a metre would not have featured!No one. A horse power is an Imperial measurement unit, not an SI unit and so a metre would not have featured!
The unit of measurement that represents true power is the watt (W).
The 3rd power (cube) of any length unit is a unit of volume.
You can't compare that. Ampere is a unit of electrical current; horse power is a unit of power.
Power
amphere is the unit of current in physics
ammeter measures the current flowing through the circuit in the unit of amphere.
You can't. You have to use the pedal's AC adapter or a Voodoo Lab Pedal Power AC. Pedal Power 2 is a DC unit; the Whammy is an AC unit.
I have an adapter that will fit into a unit that uses 4 d cell batteries. Is this too much power
The graphic processing unit (GPU) is the processor that is placed on the graphic adapter. The graphic adapter host besides the GPU some or all the graphic memory, the circuitry required to interface with the computer bus where the card is hosted on (e.g. AGP, PCIe, ...), the cooling fan and some power & cooling related modules.
Yes. There's a subtle difference in the meaning of the "--- ma" labels on the two units:-- On the "device" ... the unit that uses power ... the "200ma" is the current it useswhile it's operating.-- On the "adapter" ... the unit that supplies power ... the "800ma" is the maximumcurrent that it's able to supply. Anything less than that is easy.So your adapter is OK to operate your device. In fact, with suitable wiring and a bit ofcooling, it could nominally operate 4 of them at the same time.
I have this same problem...any answer?
In a wall adapter there is a device that converts AC to DC. Inside the adapter there is usually a transformer that reduces the voltage down to a working voltage of the equipment that the adapter plugs into. The output of the transformer is then connected to either a half wave or full wave bridge rectifier. More expensive adapters will have a resistive capacitive network in them to smooth out the ripple DC that is supplied on the output of the bridge rectifier.
Most simply, fix the unit to your windshield with the included suction cups, and plug the power adapter into a cigarette lighter socket.
There is no charger for the leapster but there is a DC adapter that powers the unit.
An external hard drive with an AC power adapter will not run down your laptop battery. A USB powered compact drive, however, will draw additional battery power through the USB interface. The benefit is that a bulky AC adapter is not needed, making the unit easier to transport.
connects the fuel source to the boiler unit