0
You work at grease monkey and have recently tested positive on your scram unit Can the gas from changing fuel filters be the cause?
Wiki User
∙ 14y ago
That is an interesting question. Since gasoline is up to 15% alcohol it could be a possibility. It is the responsibility of your company to have the MSDS on the products that you work with. They should give you that information.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you remove cooking grease from walls and aircon filters?
Wash with sugar-soap or cloudy ammonia.
What are the main components of extractor hoods?
Extractor hoods are mechanical fans used to remove grease and fumes from the air. The three main components are grease filters, a capture panel, and a fan for ventilation.
Do you need to grease anything when changing brake pads?
new pads should come with caliper grease. You dont need to use the grease but if you dont your brakes will like to squeak. It goes between the metal side of the pad and the caliper. If you dont have the grease some high temp grease will work fine.
Rock that pioneers painted name on with axle grease?
----> Independence Rock!! <---- im positive :) ^^
How to service Hino truck?
Change the oil, change the oil and fuel filters, grease it, ensure the air filter is serviceable, make sure the brakes are in spec and the wheel seals are intact, ensure the lights work, ensure the tires are legal and inflated.
Where are the heater filters in a 1999 expedition?
To the best of my knowledge, there is no heater or outside air filter on the 1999 Ford Expedition, and Grease Monkey confirmed that when my Expedition (Eddie Bauer version) was in for service.
Can aeroshell 33ms be used instead of aeroshell 33?
Answer The Shell website says that it is fully compatible with Aeroshell 33. However, note this statement: "AeroShell Grease 33MS is a direct alternative to AeroShell Grease 17, but when changing from (clay-based) ASG 17 to (Li-complex based) ASG 33MS, the normal rules on grease changing should be applied." Link: http://www.shell.com/home/content/aviation-en/aeroshell_site/33ms/grease_33ms.html
When changing the fule pump on an 1983 Chevy 350 what about the push rod that runs the pump will it fall out and is there any way to hold it in place?
You can put grease on the rod and gently push it into the block. the grease will hold it in place for a good amount of time.
How do you fix the bad smell coming out of home's air conditioning unit?
Air conditioners have filters so take the filters off and soak them in the tub with a degreaser dish soap. Clean up the rest of what you can on the air conditioner itself (if it's window installed) and spray it with Fabreeze and also give the filters a squirt of it as well. Remember, your air conditioner works hard, picks up odors and dirt, grease and impurities of all sorts so keep those filters clean!
Location of all grease points on 2003 GMC Envoy?
You do not have any. They are all sealed. I just asked the same question when the dealer was changing my oil.
Is cleaning a greasy mark from a plastic tablecloth with washing up liquid a chemical change?
No. You're not changing the chemical makeup of anything involved -- soap, tablecloth, or grease. The soap emulsifies the grease so that it can be dissolved in the water contained in the cloth you use to wipe it up.
I am changing my alxe bearings in my ATV and i put in differential oil instead of grease to lube them up will this do anything bad should i take it back apart and use grease?
yes oil is a way to thin lubracant and can become too hot were the ATV bearings will melt grease will also keep the pressure in tact unlike oil as it will spit it out every where when you go fast
