95 % of the time the nylon cord that moves the antenna up and down gets stripped. The power antenna motor is going to cost about $200.00. The antenna mast is about $40.00 which comes as part of the nylon cord. The motor that drives the antenna must bestill working. The procedure to fix takes about 15 minutes. Remove the nut that secures the antenna and slowly pull the antenna out od the socket. Take the new antenna with the nylon leadand feed it into the socket hole. You can then secure the antenna in place with the holding nut.

The rabbit antenna needs to be turned the right direction and have the two elements spread to collect enough RF signal.

Powered antennas are best in some cases, that is ones that plug in to the ac wall socket.

Also check the cable connection into the tv set antenna connector.

squeeze it a little bit with a pair of pliers until it fits snugly in the socket.

Go in the trunk, pull the carpet back and it's very straight forward. 2 screws for the bracket and unplug the antenna. The antenna unscrews from the rubber piece on the quarter panel, and then you just pop out the rubber piece in the quarter. Should take you 5 minutes with a metric socket set, 8mm I think.

First unpack the Cisco Aironet 1200. Then screw on the antenna's onto the antenna connectors. Plug the Cisco Aironet 1200 into the wall socket for power. Connect the Cisco Aironet 1200 with the internet with the use of a LAN cable and power on the device.