I have made a couple different sleeve pullers an it depends on
what typeof sleeve you are trying pull if it is a wet sleeve like
for a cat engine where the sleeve rides below the block the best
way to make one is out of 1/2" flat steel an cut it out in a "T"
shape an turn the "T" upside down an make it so the cross on the
Tprotrudes out of the sleeve by at least 1/8" an drill a hole in
the top of the leg so you can put a clevis in it. Then put a short
piece of chain on. an weld a bolt to the other end an bridge over
the top on the block an tighten the bolt an it should pull up the
sleeve An if it bends the "T" you might have make it more of a
triangle shape
An if it is a dry sleeve like in a old tractor you will need cut
one out in a circle that will just go inside the block an catch the
sleeve drill a hole in the middle of the plate an use the chain an
bolt good luck