(electronics) A harmonic conversion transducer in which the frequency of the output signal is an exact integral multiple of the input frequency. Also known as multiplier.
| Sci-Tech Dictionary: frequency multiplier |
(electronics) A harmonic conversion transducer in which the frequency of the output signal is an exact integral multiple of the input frequency. Also known as multiplier.
| 5min Related Video: Frequency multiplier |
| Sci-Tech Encyclopedia: Frequency multiplier |
An electronic circuit that produces an output frequency which is an integral multiple of the input frequency. There are two basic types of frequency multipliers. The first type is a nonlinear amplifier which generates harmonics in its output current and a tuned load that resonates at one of these harmonics. The second type uses the nonlinear capacitance of a junction (semiconductor) diode to couple energy from the input circuit, which is tuned to the fundamental, to the output circuit, which is tuned to the desired harmonic.
A highly efficient doubler can be devised by using two amplifiers, such as transistors, with their inputs driven with opposite polarity, obtained from opposite ends of a center-tapped coil, and their outputs connected in parallel. See also
| Electronics Dictionary: frequency multiplier |
A harmonic conversion circuit in which the frequency of the output signal is an exact multiple of the input frequency.
| Wikipedia: Frequency multiplier |
A frequency multiplier is commonly used in a radio receiver or radio transmitter to multiply the base frequency of the oscillator by a predetermined number. This multiplied frequency is then amplified and sent to the final drive stage and into the antenna tuning/coupling circuit for delivery to the transmitting antenna. The advantage is that a highly stable reference such as a crystal oscillator can be used, which may not be practical to manufacture for a higher frequency of interest.
Contents |
Frequency multipliers use circuits tuned to a harmonic of the input frequency. Non-linear elements such as diodes may be added to enhance the production of harmonic frequencies. Since the power in the harmonics declines rapidly, usually a frequency multiplier is tuned to only a small multiple (twice, three times, or five times) of the input frequency. Usually amplifiers are inserted in a chain of frequency multipliers to ensure adequate signal level at the final frequency.
Step recovery diodes produce harmonics with power dropping at the rate of 1/N. Such diodes can often be found in frequency muliplier circuits.
Since the tuned circuits have a limited bandwidth, if the base frequency is changed significantly (more than one percent or so), the multiplier stages may have to be adjusted; this can take significant time if there are many stages.
In digital electronics, frequency multipliers are often used along with frequency dividers and phase-locked loops to generate any desired frequency from an external reference frequency. The frequency multiplication is actually carried out quite cleverly in the phase-locked loop's feedback loop, by using a frequency divider on the output of the voltage controlled oscillator (VCO). This divided-down output is fed-back to the input comparator and compared to the reference frequency. Since the divided down frequency is smaller than the reference frequency, the comparator generates a voltage signal to the VCO, telling it to increase the output frequency. It continues to do this via the feedback loop, raising the VCO output frequency, until the divided-down frequency from the VCO output is equal to the reference frequency. At this point the comparator stabilizes and generates no more signals to the VCO, or only minor changes to maintain stability. The output frequency from the VCO will be stable at the input reference frequency multiplied by the value of the feedback divider.
A PLL with a frequency divider in its feedback loop acts as a frequency multiplier and is a type of frequency synthesizer.
In a configuration with an integer-N divider, its VCO's output frequency is N times its reference, or input, frequency.
Periodic changes in the integer value of an integer-N frequency divider will effectively result in a multiplier with both whole number and fractional component. Such a multiplier is called a fractional-N synthesier after its fractional component. Fractional-N synthesizers provide an effective means of achieving fine frequency resolution with lower values of N, allowing loop architectures with tens of thousands of times less phase noise than alternative designs with lower reference frequencies and higher integer N values. They also allow a faster settling time because of their higher reference frequencies, allowing wider closed and open loop bandwidths.
A delta sigma synthesizer adds a randomization to programmable-N frequency divider of the fractional-N synthesizer. This is done to shrink sidebands created by periodic changes of an integer-N frequency divider.
This entry is from Wikipedia, the leading user-contributed encyclopedia. It may not have been reviewed by professional editors (see full disclaimer)
| reactance frequency multiplier (electronics) | |
| nonlinear coupler (electronics) | |
| push-push amplifier (electronics) |
Copyrights:
![]() | Sci-Tech Dictionary. McGraw-Hill Dictionary of Scientific and Technical Terms. Copyright © 2003, 1994, 1989, 1984, 1978, 1976, 1974 by McGraw-Hill Companies, Inc. All rights reserved. Read more | |
![]() | Sci-Tech Encyclopedia. McGraw-Hill Encyclopedia of Science and Technology. Copyright © 2005 by The McGraw-Hill Companies, Inc. All rights reserved. Read more | |
![]() | Electronics Dictionary. Copyright 2001 by Twysted Pair. All rights reserved. Read more | |
![]() | Wikipedia. This article is licensed under the Creative Commons Attribution/Share-Alike License. It uses material from the Wikipedia article "Frequency multiplier". Read more |
Mentioned in