drain oil, remove all bolts holding oil pan to block. remove 0-2
senso cable, remov front exhaust pipe, remove flywheel cover, use a
"lipped" pull tool to hook onto he pan lip and pull one corner
loose and finish pulling pan off. thoroughly clean out pan and pan
ridge of all foreign material/debris, clean all bolts of
sludge,dirt, debris and spray with silicon lubrican (to ease
re-install) as well as the block surface. when insalling, put a
thin bead of ATV sealant on oil pan ridge, apply to block, hold
with one hand (left hand if right-handed) and install 2 opposite
corner bolts and hand tighten. install remaining bolts hand tight.
finish tightening to 6-7 ft-lbs. be sure oil plug is in and
tight!!!