there are two types of master cylinders

1.single cylinder

2.tendom master cylinder

Bank one is on the side that the master cylinder is on bank two is the opposite side of the master cylinder

2 reasons:

1. There is no fluid in your master cylinder due to a leaking master cylinder or slave cylinder

or

2. You blew your clutch

a heater does not have a master cylinder; 'master cylinder' goes with assisted braking.

In order to replace the master cylinder with ABS attached to the master cylinder on a 1995 Grand Am you will need to complete the following steps:

• Disconnect the negative battery cable.
• Locate the master cylinder which is attached to the drivers side of the firewall.
• Remove the ABS brake line from the master cylinder using a wrench.
• Disconnect the fluid hose from the master cylinder using a wrench.
• Unscrew the nuts that hold the master cylinder in place.
• Remove the master cylinder and install a new one.
• Reattach the fluid hose to the master cylinder.
• Reattach the ABS brake line to the master cylinder.
• Tighten all the nuts and bolts and reconnect the negative battery cable.

Once all of these steps have been completed you can be sure that your master cylinder has been properly replaced and is ready for use.