monorail

The KL Monorail in Kuala Lumpur, a colourful straddle-beam monorail

A monorail is a rail-based transportation system based on a single rail, which acts as its sole support and its guideway. The term is also used variously to describe the beam of the system, or the vehicles traveling on such a beam or track. The term originates from the contraction of the words mono (single) and rail, from as early as 1897^[1] as early systems used metal rails. The transportation system is often referred to as a railway.^[2] In contrast, a light rail system has two rails sharing support of the train which also share the responsibility of guiding the train.

Colloquially, the term "monorail" is often used erroneously to describe any form any elevated rail or peoplemover.^[3] In fact, the term solely refers to the style of track, not its elevation.

Differentiation from other transport systems

Monorail systems have found shared applications in the transportation market in airport transfer and some medium capacity metro systems. To differentiate monorail systems from other transport modes, the Monorail Society further clarifies the definition of a monorail such that the beam in a monorail system is narrower than the vehicle.^[4]

Similarities

Monorails are often but not exclusively elevated, sometimes leading to confusion with other elevated systems such as the Docklands Light Railway, Vancouver SkyTrain and the JFK AirTrain. Monorail vehicles are often at first glance similar to other light rail vehicles, and can be both manned and unmanned. Monorail vehicles can also be found in singular rigid format, articulated single units, or as multiple units coupled into 'trains'. In common with other advanced rapid transit systems, some monorails are driven by linear induction motor. In common with other dual rail systems, the vehicle bodies are connected to the beam via bogies, allowing curves to be negotiated.

Differences

Unlike some trams and light rail systems, modern monorails are always partitioned from other traffic and pedestrians. Monorails are both guided and supported via interaction with the same single beam, in contrast to other guided systems such as Rubber-tyred metros, such as the Sapporo Municipal Subway; or guided buses or trams, such as Translohr. Monorails also do not use pantographs.

Maglev

Under the Monorail Society beam width criteria, some but not all maglev systems are considered monorails, such as the Transrapid and Linimo. Maglevs differ from all other monorail systems in that they do not (normally) physically contact the beam.

History

Gyroscopically balanced monorail (1907) by Brennan and Scherl

Early years

The first monorail was made in Russia in 1820 by Ivan Elmanov. Attempts at creating monorail alternatives to conventional railways have been made since the early part of the 19th century. The earliest patent was taken out by Henry Palmer in the UK in 1821, and the design was employed at Deptford Dockyard in South-East London, and a short line for moving stone from a quarry near Cheshunt, Hertfordshire to the River Lea. The Cheshunt line is notable as it was the world's first monorail to carry passengers, as well as the first railway line to be opened in Hertfordshire.^[5][6]

Early designs centred on use of a double-flanged single metal rail alternative to the double rail of conventional railways. Wheels on this rail would both guide and support the monorail car. A surviving suspended version is the Wuppertal monorail. Into the 1900s, Gyro monorails, with cars gyroscopically balanced on top of a single rail, were tested but never developed beyond the prototype stage. The Ewing System, used in the Patiala State Monorail Trainways in Punjab, India, relies on a hybrid model with a load-bearing single rail and an external wheel for balance. One of the first systems put into practical use was that of French engineer Charles Lartigue, who built a monorail line between Ballybunion and Listowel in Ireland, which was opened in 1888 and closed in 1924 (due to damage from Ireland's Civil War). The Lartigue system uses a load-bearing single rail and two lower, external rails for balance, the three carried on triangular supports.

1900s-1950s

The first half of the 20th century saw many further proposed designs, that either never left the drawing board or remained as short lived prototypes.

1950s-1980s

In the latter half of the 20th century, monorail designs had settled on using larger beam or girder based track, with vehicles supported by one set of wheels and guided by another. These designs featured vehicles supported, suspended or cantilevered from the beams. In the 1950s the ALWEG straddle design emerged, followed by an updated suspended type, the SAFEGE system. Versions of ALWEG's technology are currently used by both of the two largest monorail manufacturers, Hitachi Monorail and Bombardier.

During this period, major monorails were installed at Disneyland in California, Walt Disney World in Florida, Seattle, Japan, and many other locations. Monorail systems were also heavily promoted as futuristic technology with exhibition installations and amusement park purchases, as seen by the number of legacy systems in use today. However, monorails gained little foothold compared to conventional transport systems.

Niche private enterprise uses for monorails emerged, with the emergence of air travel and shopping malls, with many shuttle type systems being built.

Perceptions of monorail as public transport

From 1950 to 1980 the monorail concept may have suffered, as with all public transport systems, from competition with the automobile. Monorails in particular may have suffered from the reluctance of public transit authorities to invest in the perceived high cost of un-proven monorails when faced with cheaper mature alternatives. There were also many competing monorail technologies, splitting their case further.

This high cost perception was challenged most-notably in 1963, when the ALWEG consortium proposed to finance the construction of a major monorail system in Los Angeles, in return for the right of operation. This was turned down by the city authorities in favour of no system at all, and the later subway system has faced criticism as it has yet to reach the scale of the proposed monorail.

Several monorails initially conceived as transport systems survive today on revenues generated from tourism usage, benefitting from the unique views offered from the largely elevated monorail installations.

Resurgence

From the 1980s onwards, with the rise of traffic congestion and urbanization, monorails have experienced a resurgence in interest for mass transit usage, notable from the early use by Japan and now Malaysia. Tokyo Monorail, the world's busiest monorail line, averages 127,000 passengers per day and has served over 1.5 billion passengers since 1964.^[7] Monorails have also seen continuing use in niche shuttle markets, as well as amusement parks.

Modern mass transit monorail systems have settled on developments of the ALWEG beam and tyre approach, with only two suspended types in large use. Monorail configurations have also been adopted by maglev trains.

Types and technical aspects

The Schwebebahn Wuppertal, the world's first suspended monorail

Modern monorails depend on a large solid beam as the vehicles' running surface. There are a number of competing designs divided into two broad classes, straddle-beam and suspended monorails.

The most common type of monorail in use today is the straddle-beam monorail, in which the train straddles a reinforced concrete beam in the range of two to three feet (~0.6-0.9 m) wide. A rubber-tired carriage contacts the beam on the top and both sides for traction and to stabilize the vehicle. The straddle-beam style was popularized by the German company ALWEG.

There is also a form of suspended monorail developed by the French company SAFEGE in which the train cars are suspended beneath the wheel carriage. In this design the carriage wheels ride inside the single beam. The Chiba Urban Monorail is presently the world's largest suspended monorail network.

Power

Almost all modern monorails are powered by electric motors fed by dual third rails, contact wires or electrified channels attached to or enclosed in their guidance beams. However, diesel-powered monorail systems also exist.^[8]

Magnetic levitation

Transrapid maglev on monorail track

Magnetic levitation train (maglev) systems by the German Transrapid were built as straddle-type monorails, as they are highly stable and allow rapid deceleration from great speed. When in full-speed operation maglev trains hover over the track and are thus not in physical contact with it. The maglev is the fastest train of any type, the experimental JR-Maglev having recorded a speed of 581 km/h (361 mph). The commercial Shanghai Maglev Train has run at 501 km/h (311 mph).

In addition, Linimo was inaugurated in Japan in 2003.

Switching

Switches at storage facility of Osaka Monorail.

Some early monorail systems—notably the suspended monorail of Wuppertal (Germany), dating from 1901 and still in operation—have a design that makes it difficult to switch from one line to another. Some other monorail systems avoid switching as much as possible, by operating in a continuous loop or between two fixed stations, as in Seattle, Washington.

Current operating monorails are capable of more efficient switching than in the past. In the case of suspended monorails, switching may be accomplished by moving flanges inside the beamway to shift trains to one line or another.

The Metro Monorail in Sydney avoids switching by operating in a single loop.

Straddle-beam monorails require that the beam structure itself be moved to accomplish switching, which originally was an almost prohibitively ponderous procedure. Now, however, the most common way of achieving this is to place a moving apparatus on top of a sturdy platform capable of bearing the weight of vehicles, beams and its own mechanism. Multiple-segmented beams move into place on rollers to smoothly align one beam with another to send the train in its desired direction, with the design originally developed by ALWEG capable of completing a switch in 12 seconds.^[9] Some of these beam turnouts are quite elaborate, capable of switching between several beams or even simulating a railroad double-crossover.

In cases where it must be possible to move a monorail train from one beam to any of a number of other beams, as in storage or repair shops, a traveling beam not unlike a railroad transfer table may be employed. A single beam, at least long enough to carry a single monorail vehicle, is aligned at an entry beam to be mounted by the monorail cars. The entire beam then rolls with the vehicle to align with the desired storage beam.

Advantages and disadvantages

The high capacity Tama Toshi Monorail Line.

Advantages

• The primary advantage of monorails over conventional rail systems is that they require minimal space, both horizontally and vertically. Monorail vehicles are wider than the beam, and monorail systems are commonly elevated, requiring only a minimal footprint for support pillars.
• A monorail track is usually less expensive to build than a comparable elevated conventional rail line of equal capacity.
• Due to a smaller footprint they are seen as more attractive than conventional elevated rail lines and block only a minimal amount of sky.
• Monorail is, by design, a grade-separated system. They do not interfere with existing transport modes.
• They are quieter, as modern monorails use rubber wheels on a concrete track (though some non-monorail subway systems, like certain lines of the Paris Métro and all of the Montreal metro and Mexico City metro, use the same technique and are equally quiet)
• Unlike conventional rail systems, straddle monorails wrap around their track and are thus not physically capable of derailing, unless the track itself suffers a catastrophic failure.
• Rubber-tired monorails can grip track on both sides and thus climb steeper grades better than ordinary trains, with Hitachi monorails designed to cope with 6% grade.^[10]

Disadvantages

The Mud Island Monorail, in Memphis, Tennessee (2005)

• Monorail vehicles are not compatible with any other type of rail infrastructure, which makes (for example) through services onto mainline tracks impossible.
• Monorail tracks do not easily accommodate at-grade intersections.
• In an emergency, passengers may not be able to immediately exit because an elevated monorail vehicle is high above ground and not all systems have emergency walkways. The passengers must sometimes wait until a rescue train, fire engine or a cherry picker comes to the rescue. Newer monorail systems resolve this by building emergency walkways alongside the entire track, at the expense of visual intrusion. Suspended railways resolve this by building aircraft style evacuation slides into the vehicles. Japanese systems use the next train to tow broken down trains to the next station, but this has yet to occur.^{[citation needed]}
• Turnouts, especially at high speeds, may be marginally more difficult compared to conventional railway points, although certainly not impossible.
• Monorail infrastructure and vehicles are often made by separate manufacturers, with different manufacturers using incompatible designs.

Monorail systems

Main article: List of monorail systems

See also

Wikimedia Commons has media related to: Monorail

• Slope car
• Transrapid

References

External links

Monorails in general

• Minirail at the Expo 67
• Innovative Transportation Technologies - a website for the Transportation engineering and Urban planning programs at the University of Washington
• The Disneyland Monorail - Article on how a rubber-wheeled monorail works.
• The Monorail Society - home page of a volunteer organization promoting monorails, with separate pages on monorail switches and a backyard monorail
• "One-Track Wonders: Early Monorails" - Site with lots of images of imagined and real monorails
• The unknown russian monorail - in Russian
• Maglev Monorail - Official site of the International Maglev Board

Monorail advocacy groups

• 2045 Seattle - a grassroots movement that supports the construction of rapid transit monorail in Seattle, WA
• Austin Monorail Project - a non-profit advocating monorail transit for Austin, TX
• The Monorail Society - an all-volunteer organization founded to foster more awareness and promote this unique method of transportation

Organizations/views opposing monorails

• Las Vegas Monorail: Troublesome Technology in a Unique "Niche" Application - a critical article on the Las Vegas Monorail from Light Rail Now!, a pro-light rail organization in Austin, TX opposed to monorails
• Monorail Capital Costs: Reality Check - a critical article on the capitial costs of monorails. From Light Rail Now!
• Monorails, Light Rail, and Automated vs. Non-Automated Transit Operation: Comparative Costs in Japan and USA - a critical article on the cost differences of monorails, whether they are automated or not. From Light Rail Now!