0
'Where is ignition coil 2 in a 1998 Nissan Maxima'?
What else can I help you with?
Where is ignition control module 1987 Nissan Maxima?
under the coil
Where is ignition coil 4 in a 1999 Nissan Maxima?
Ignition coil 4 is the center coil (plug) on the bank closest to the radiator. FYI, #1 is passenger side, closest to firewall, #3 is center, firewall, #5 is driver's side firewall, etc. Good luck.
How do you diagnose a bad coil on 1993 Nissan Maxima SE?
autozone.com click repair on the right, and follow the directions. Then click engine electrical, then ignition system.
How do you change ignition coil in Nissan sentra 2001?
How change my ignition switch nissan 2001 sentra.
How do you remove the distributor wires and cap from the sparkplugs on the 95 maxima?
1995 Nissan maximas do not have dist caps they have individ coil packs on top of the v covers
Where is coil located 1994 Nissan Maxima?
passenger side of intake manifold
Replace the rear 3 spark plugs on 2004 Nissan maxima 3.5 sl?
Here is the link to the step by step guide Spark Plug / Ignition Coil Replacement -ChrisB
Where is located ignition ballast resistor on 1999 Nissan Maxima?
On a 1999 Nissan Maxima, the ignition ballast resistor is typically located in the engine compartment, near the firewall or close to the ignition coil. It may be mounted on the fender or near the battery, depending on the specific configuration. To access it, you might need to remove some covers or components in the area. Always refer to the vehicle's service manual for precise location and identification.
What could need fixing on a 2000 Nissan maxima with the check engine light on and otc scan reading multiple misfire on cylinder 1?
Probably the number two ignition coil. Also check the spark plug and the wiring to the coil.
What is the p1320 ob2 code for Nissan Maxima?
Change The coil ,, and its bettert to change it all
How do you know what coil is bad on a 2001 Nissan Maxima 3.0 e?
To determine which coil is bad on a 2001 Nissan Maxima 3.0, you can perform a cylinder balance test or use an OBD-II scanner to check for any misfire codes. If a specific cylinder is misfiring, it can indicate that the corresponding ignition coil is faulty. Additionally, you can visually inspect the coils for damage or corrosion and swap coils between cylinders to see if the misfire follows the coil to a different cylinder. If the problem moves, the swapped coil is likely the culprit.
How do you test a Geo Metro 1995 ignition coil?
A 1995 Geo Metro ignition coil is tested by measuring the resistance across the coil. If it exceeds the manufacturer's recommendation, it must be replaced.
