answersLogoWhite

0

The square connector on the front of the transaxle is for the locking torque converter.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the coil wire on 1990 Chevy Celebrity?

The coils are bolted to the ignition control module, there is no coil wire as such.


What is the correct wire by color to hook up to a yellow memory wire for a CD player in a 1988 Chevy Celebrity?

the red one


Will a93 Chevy valvebody wire harness fit a 99 Chevy valvebody transmission?

No. Very different.


Do oil pressure switches leak at wire connection on 88 Chevy Celebrity?

yes usually from over revving


Where can you find speed sensor wire on a 2002 Chevy Prizm?

in the valve body in transmission pan


Where is the wire connection for the 02 sensor on a 1987 Chevy Chevelle?

no chevelle was ever made in 87.


How do you remove the front speakers from a 1989 Chevy Celebrity?

To remove the front speakers from a Chevy Celebrity: 1. Take out the screws from the speaker grills, take the grills out. 2. The speaker is held in with screws, remove them. Lift the speakers out of the dash and unplug the wire harness.


How do you change the headlight on an 89 Chevy Celebrity?

To change the headlight bulb on a 1989 Chevy Celebrity reach down in behind the composite headlight fixture and disconnect the appropriate wire plug then give the bulb a counter clockwise twist, and pull it out. Reverse the process to install a new bulb.


On a 1987 Chevy pickup 350 what wire is used for a tach not hei?

For a 1987 Chevy pickup with a 350 engine and a non-HEI ignition system, the wire that is typically used for connecting a tachometer is the green wire located on the distributor cap. This wire provides the signal needed for the tachometer to work accurately. Make sure to consult the vehicle's manual or a wiring diagram to locate the specific wire on your truck.


How do you change the speed sensor on 1990 Chevy Celebrity?

The speed sensor on a 1990 Chevy Celebrity is on the top of the transaxle on the passenger side of the car. To change it unlatch and remove the wire harness then remove the two bolts that hold it in. The speed sensor can then be lifted out of the transaxle. To reinstall a new sensor reverse these steps.


Where is the speed sensor wire for 01 Chevy Venture van?

passenger side transmission housing where the half shaft connects from the wheel


How do you change speed sensor on Chevy Silverado?

The speed sensor on a Chevy Silverado is located on the tailshaft of the transmission. To remove it, unplug the wire hardness, unscrew the bolt holding it in place, and pull it out.