answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2006-07-04 22:37:39

your fan relay switch your fan relay switch

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions



On the cylinder head close to the thermostat housing.


Be careful there is a temperature coolant switch mounted next to the thermostat housing. I thought this was the sensor and replaced it by mistake. There is another sensor.


the sensor is on the the thermostat housing, youll see one on top(fan sensor)the other is underneath the housing.the housing will have to be removed to change it


it is on the top of the thermostat housing on the drivers side of the engine


thermostat housing on the side of the engine block


The engine temp sensor is on the front of the engine, next to the thermostat housing.The engine temp sensor is on the front of the engine, next to the thermostat housing.


There is an engine temperature sensor that operates the cooling fan.


It will depend on which engine you have. The 2.0 DOHC has 2 sensors; one for the temp gauge and one for the ECM. The temp sensors are both located on the thermostat housing; one is on top and one is on the bottom of the housing. The Sensor on the bottom of the thermostat housing is for the temp guage. The other i believe may be for the fan but it does not match the sensor for the ECM. Ive been to autozone advanced auto and oreilly, the sensor for the ecm is different than the one on top of the thermostat housing


The speed sensor on a 1997 Escort is located on the transmission. It is right behind the bell housing. The Code PO715 means that this sensor needs to be fixed or replaced. This sensor can sometimes pop out of its plug, so do not purchase a new one until this is checked.


Most vehicles locate that sensor close to the thermostat housing.


There is 2 of them and they are located on either side of the thermostat housing.


Check your connection with the fan on/off sensor. Should be located somewhere on the thermostat housing. Sometimes if there is no signal, the fan will stay on (failsafe). Could also be the sensor



The 1988 Dodge Dynasty coolant fan sensor is located a few inches above the thermostat housing. The thermostat housing can be found on the front of the engine.


The thermostat housing is located on the driver side between the distributor and the transmission. There are two 12mm bolts holding the the thermostat housing. You may want to disconnect the white colored sensor before removing the housing. The thermostat is located underneath the housing.


1 temp sensor is under the spark plugs by the dipstick, cylinder head temp 1 temp sensor is in the thermostat housing 1 temp switch is beside the temp sensor in the thermostat housing


The coolant sensor is the two wire sensor that is next to the thermostat housing.


It is the two wire sensor near the thermostat housing.


a temp sensor is located on the intake or the thermostat housing


It is located to the left of the thermostat housing for the temperature gauge, there is another to the right of the thermostat housing for the computer.


On the left hand side of the engine is the thermostat housing. The camshaft position sensor is located directly above the thermostat housing on the end of the cylinder head.






Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.