0
What else can I help you with?
How do you program keyless entry remote for 1989 Buick Park Avenue?
The 1989 Buick Park Avenue does not come with a remote keyless entry. The keyless remote entry was not available till 1997.
How do the brake lines on 1989 Buick Park Avenue run?
by your mom
Where is voltage regulator on 1989 Buick Park Avenue?
Inside the alternator.
How do you change heater core in 1989 Buick Park Avenue?
89 Buick park ave install a heater coil
Size of Brake lines for 1989 Buick Park Avenue?
I believe they are 3/16"
Computer for 1989 buick park avenue?
For model year 1989 General Motors did not produce the Buick Park Avenue. The soonest production date to 1989 was the 1991 Park Avenue. The 1991 Park Avenue was offered in 3800 engine in supercharged or naturally aspirated. The part numbers for electronic control module (ECM) or "computer" will vary based on the exact engine for model year 1991s.
1989 Buick Electra Park Avenue blower motor location?
Blower motor is located on the firewall behind the engine.
What is causing a clicking noise when turning right or left in 1989 Buick Skylark?
CVC joint needs replacing. This can be dangerous, have it repaired.
Will a Nissan engine work in a 1989 Buick park avenue?
no,but a buick park ave 92- 94 or 95 ,has the same trans as a front -wheel drive VOLVO X C -90
Where is the fuse box for a 1989 Buick park avenue?
The fuse box for a 1989 Buick Park Avenue is typically located under the dashboard on the driver's side. You may need to remove a cover panel to access it. Additionally, there is a second fuse box located in the engine compartment, near the battery. Always refer to your owner's manual for specific locations and details.
Where is the fuel pump located and how do you replace it on a 1989 Buick Park Avenue?
In the gas tank. Unless there is an access panel in the trunk, the tank must be removed to change the pump.
On a 1989 Buick Electra Park Avenue how many motor mounts does it have and transmission mounts?
The 1989 Buick Electra Park Avenue typically has three motor mounts and one transmission mount. The motor mounts are designed to secure the engine to the frame while absorbing vibrations, and the transmission mount serves a similar purpose for the transmission. Always refer to the specific service manual for your vehicle for the most accurate information.
