answersLogoWhite

0


Best Answer

check your fuel pump.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1990 jeep Cherokee Laredo wants to stall when you lightly press on the gas what can you do to fix this?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why would your 1994 Jeep Grand Cherokee Laredo stall briefly and your speedometer jump?

Having the speedometer jump and the engine stall in the 1994 Jeep Grand Cherokee Laredo could be a problem with the idle and the transmission. The transmission slipping can cause the speedometer to jump.


Could the Crank Shaft Position Sensor cause a 1999 Jeep Grand Cherokee Laredo to stall driving up the road doing 65?

Yes


Why would 2000 Jeep Cherokee stall out in idol?

faulty throttle position sensor?


What causes 89 Jeep Cherokee to stall after being diven?

Check the operating mechanism


What would cause a 1993 Jeep Grand Cherokee to start stall and then restart?

usually the factory alarm


What would cause a 1994 grand Cherokee limited to stall during cold weather?

bad fuel filter


If the neutral safety switch is bad would a 1994 Jeep Cherokee stall?

No. It would only prevent you from starting.


What is diagnostic code 43 in a 1997 Jeep Grand Cherokee?

Diagnostic code 43 in the 1997 Jeep Grand Cherokee refers to an issue with the distributor. This often causes the Jeep to stall at operating temperature.


Why does your car stall when you press the gas pedal or you put it in reverse?

youre lifting the clutch up to quick


Would a bad oxygen sensor cause my 97 grand Cherokee to intermittently stall while driving?

I had that same exact problem with a 1995 Jeep Cherokee, and it was indeed a bad oxygen sensor. Relatively cheap repair too.


How to increase the light output of jeep Cherokee sport head lights?

in stall fog lamps it helps a lot or ultra whites from auto store


What would cause a 1998 Cherokee to stall while driving and not start not even push starting it?

Check the crank angle sensor usually about $150 to replace