The Oldsmobile Cutlass Ciera a was front wheel drive model. It was sold by General Motors from 1982 to 1996.
I would say front wheel drive
It would be a front wheel drive car... the only 'car' from Honda that i know of that's rear wheel drive would be the s2000 and the NSX... a shame
no it is defently rear wheel ================================================== That would depend on which model year , there have been rear wheel drive and front wheel drive versions of the Mercury Cougar
No , why would you!
That would depend on which model year of Chevrolet Malibu ( both rear wheel drive and front wheel drive versions have been made )
To pay someone to do this job would not be cost effective. Better to buy a rear wheel drive vehicle and sell the front wheel drive vehicle.
if it is front wheel drive then you need new drive axels
pretty much you dont convert front wheel drive to rear wheel drive it would involve new engine, new transmission, new differential, new drive shaft etc just cost prohibitve and you would have to change suspension and a lot of engineering would be required just buy a rear wheel drive vehicle
All true trucks are rear wheel drive or 4 wheel drive. Because of towing and payload needs trucks are rear wheel drive or 4wheel drive. If you have a heavy loadd in the back of the truck and it was front wheel drive you would not get any traction, the same as if you towing a load.
Most front wheel drive wheel bearing/hub assemblies are not serviceable.
No there rear wheel drive rims are different than front drive rims
Impossible. Rx7 is rear wheel drive and Protege is front wheel drive.