burp the water system that may help
NO!!!!!
No, there should not be pressure in the radiator after cooling down. If there is still pressure, it could indicate a problem with the radiator cap or the cooling system, such as a leak or a failing pressure release valve.
Rust and sediment can accumulate in the cooling system. Flushing the radiator helps keep the cooling system clean.
The radiator cap controls cooling system pressure.The radiator cap controls cooling system pressure.
The radiator is part if the cooling system.
Motor cooling system? The engine cooling system consits of the water pump, radiator, hoses, cooling fans, etc.Motor cooling system? The engine cooling system consits of the water pump, radiator, hoses, cooling fans, etc.
I assume you meant 95 Ford Contour. There is no bleeding when replacing antifreese. Just fill the radiator recovery tank as there is no radiator cap on these vehicles.
there are two metal looking lines that screw into the radiator that is the cooling side
Many things can cause an engine to run hot, make sure that the cooling system is full, that there are no leaks, make sure the cooling fan is operating properly, make sure that the there is nothing blocking air circulation thru the radiator fins, check for corrosion inside the radiator causing blockage and reduced cooling.
The radiator is located in front the engine cooling fan and shroud, at the front of the motor. _____________chassis_________________ _____________________________________ Fire wall motor ~cooling fan~ radiator ________________________________________ chassis
The cooling system.
yes...