0
What else can I help you with?
What kind of fluid is in a 1993 jeep wrangler manual transmission?
75w90
Where is the fill plug on a manual transmission on a 1993 jeep wrangler?
There are two large flat hex plugs on the driver's side of the transmission. The upper hex bolt plug is the fill plug.
How much transmission fluid does an 1993 Mustang manual take?
In the 1993 manual transmission Mustang the capacitie is 5.6 pts.
Which is the auto transmission oil for Jeep Wrangler 1993?
Mopar ATF+4
Can you put a manual transmission in a 1993 Lincoln town car?
Yes, you can put a manual transmission in a 1993 Lincoln Town Car. The purpose of the engine is to provide motion to the transmission.
What kind of auto transmission fluid does a 1993 Jeep Wrangler have?
Mopar ATF+4
Does a 1993 Ranger manual transmission use Dextron transmission fluid?
According to Haynes Repair Manual #36071, 1993-2005 Ford Ranger pickups, all models: Manual transmission fluid type is MERCON automatic transmission fluid.
What oil to use in 1993 wrangler transfer case?
Dextron mercon 3 transmission fluid.
Where is the dipstick transmission fluid to a 1993 mustang with a manual transmission?
No dipstick on the manual transmission , fluid level is checked underneath the car at the transmission fill plug
What is the fluid capacity of a 93 wrangler automatic transmission with 4.0 liter engine?
The fluid capacity of a 1993 Jeep Wrangler with a 4.0-liter engine and an automatic transmission is approximately 12 quarts when including the torque converter. It's important to check the owner's manual for specific recommendations and to verify the fluid level after a transmission service, as the total capacity can vary slightly based on the specific transmission model and any modifications.
Where can you find an owners manual for a 1993 Jeep Wrangler?
I found a Owners Manual on Ebay for my Jeep and the cost was around $20.00 at the time
How do you add manual transmission fluid to a 1993 jeep wrangler?
Locate the fill plug half way up the side of the transmission on the drivers side, it is usually a torx type bolt. fill through this hole until a little runs back out and it will be full.
