Try having the throttle body cleaned.
If a Nissan Sentra stalls when making turns, check the fuel and spark. The coil may be cutting out when it gets hot.
hi i want to know why when i press the clutch i hear noise
When replacing or making changes to the vacuum line of a car, it comes in handy to have a diagram. A diagram for this cars vacuum line can be found in the maintenance manual.
Becase They Think That The 350Z Was The The Future OF Nissan Was The Nissan 350Z So That's Why They Stop Making The Skylines
If the service light comes on it usually mean there is maintenance needed to be done elsewhere than the engine. Try making sure all your lights work including break lights, turn signals head lights, parking lights, etc.
AutoZone will check your computer codes for FREE.
Check the engine coolant temprature sensor it may be sending the wrong signals to the ECU making the ECU think the engine is cold and overfueling the engine.
Why is your 1993 Altima Nissan making a clicking noise but does not start?
No but if you do it wrong (oily filter or leaky connection) you can damage the sensor while driving making it necessary to replace that sensor later.
No. Nissan Motor Co., is still currently producing the Nissan Pathfinder. For more info visit the Nissan website.
I as well have a 1989 Sentra that would do the same and the problem was that when the engine got warm, the oil started to leak into the distributor. The oil would mess up the ignition timing, hence the poor idle and non burn issues. Take apart your distributor and see if there is any oil in it. It is very easy to take off the car, 2-12mm bolts DO NOT turn the engine over while the distributor is out, and make sure it goes in the same way it came out (rotor pointing in the same direction). Good luck!
You need a code reader, so you can find out what is making this engine light come on. This way you will fix problem. You can also clear codes, turn engine lights off with it. It a great investment.
Check the light control switch mounted on the steering column. The copper or brass switch block is not making contact.
they have not stopped making it.
you bring your car to your local mechanic. now wasn't that simple? I'll include a video below along with the actual part, so that you can save yourself some time and money with making the repair yourself. It can be done with simple hand tools.
by making light
Lights TV - 2008 The Making of the dLite Animated Video Featuring Lights 2-14 was released on: USA: 23 September 2010
You haven't by any chance dropped something down a sparkplug hole! Small nut or bolt!
"The Nissan Primera is considered a reliable car, Nissan was known for making reliable cars that were hard on the eyes. They redesigned the Primera to be both reliable and Aesthetic."
If it's the CV axle it slings grease EVERYWHERE when it goes bad. Technically, your wheel could fall off. Check the CV boots. (the rubber thing around where the axle meets the engine) If they're ripped or torn, they could probably use to be replaced. But my CVboots have been torn for about 2 years now and nothing has happened besides just making noise at higher speeds.
The Nissan 350z costs anywhere from $36,000-$42,000. They stopped making 350z for 2011. They now only sell 370z.
Currently Nissan makes the car model Pathfinder. Nissan has been making the Pathfinder since 1986 and are now Mid-size SUVs.
timing chain making a noise?
1996, but they continued to make it until 2000 in Japan.