Rotors out of round - need to be re-surfaced or replaced
Bad ground, usually at the rear lights.
did you check the oil level yet?
If the back dash light will light when the brakes are applied but the two tail lights will not light up, there is probably a short in the wiring somewhere. It could also be that the fuse for the brake lights is burned out.
Kinda need more information. Is it just when accelerating, or also when idling in drive? Does it only do it at a certain rpm or speed, or when applying brakes?
It sounds like when the wheels were put back on, the lug nuts were over tightened or tightened out of sequence causeing the rotors to warp. if they did not turn the rotor or they were cut wrong it could cause that. some places say they changed it but might of turned them.
Get thee to the vet!
It's impossible to say what the problem is based on your description but obviously there's a serious problem going on there. I would look first at suspension components and then brakes. You really should take this in for a diagnostic check and an estimate of repair cost. Usually this wouldn't cost you a penny for a look-see and will give you a better idea of what is wrong. This sounds like an issue that you should immediately address due to safety concerns.
You talk to her and ask her what is wrong ,or what she dose not like about you.
that would be your brakes are bad mabe your rotors have to be turn now....
Your tires probably just need to be balanced.
I have to pump my brakes what čould be wrong
brakes need replaced