Best Answer

( bulb # 168 ) for a 1996 Ford Mustang

license plate light

User Avatar

Wiki User

2013-10-10 06:40:04
This answer is:
User Avatar
Study guides

What unit is used to measure resistance

A 5 ohm resistor a 10 ohm resistor and a 15 ohm resistor are connected in series to a 120 volt power source What is the amount of current flowing between the 5 ohm resistor and the 10 ohm resistor

What is the equivalent resistance through the parallel portion of the circuit

What is the drawing of an electrical circuit called

See all cards
3 Reviews

Add your answer:

Earn +20 pts
Q: 1996 Ford Mustang license plate light?
Write your answer...
Still have questions?
magnify glass
Related questions

How do you change the license plate light on a 1996 Dodge Neon?

If you kneel down and look up at the license plate, you should be able to see it. The bulb just pulls straight out of the socket.

How do you change the light bulbs for the license plate of 1996 BMW z3?

Reach under the car and feel the back of the license plate light. There's a metal clip, which when squeezed, will allow you to easily pop the license plate light out. Then simply twist the part holding the bulb 90 degrees, and you'll be able to pull the socket out and replace the bulb.

How do you replace the rear license plate bulb on a 1996 Olds Cutlass Supreme?

The rear license plate bulbs on a 1996 Olds Cutlass Supreme are replaced by removing the retaining screws, pulling the light assembly out, and disconnecting the wiring harness. The bulb can then be twisted to remove it and a new bulb put in place.

Will a 1996 Ford Mustang tail light fit a 1998 Ford Mustang?

Yes, these tail lights are interchangeable.

How do you remove 1996 corvette front license plate cover?

There are screws holding it on. Un-screw them.

How do you replace a License plate bulb on 1996 Dodge Ram Van 2500 series?

take license's plate off.then unbolt the two hex nuts at top of bumper this is the bolts to take off the housing holding the light over the license plate. then you have two screws to take off the bulb cover. push bulb down and twist to left to get out. just do this in reverse to put back together.

What is the horsepower of a 1996 mustang gt?

The 1996 Ford Mustang GT was rated at 215 horsepower

How much horsepower in 1996 mustang gt?

The 1996 Ford Mustang GT was rated at 215 horsepower

Transmission Modulator 1996 Ford Mustang?

Transmission Modulator 1996 ford mustang can not find location

Is there a fuse for the license plate lights on a 1996 Mercury villager?

Should be the same circuit for parking/tail/dash lights

How to change the tag light on a 1996 Cadillac Deville?

You would think this would be easy, but I just bought my first Caddy and had to have a buddy show me how to change the tag light. 1. Remove (2) screws holding license plate. 2. Remove (4) screws under license plate. 3. Open trunk and remove front of trunk lid carpeting. 4. Remove (2) screws behind back up lights. 5. Pull out back up light/license plate holder housing from trunk. 6. Replace bulb. 7. Put everything back in reverse order.

Will a 2001 mustang hood fit a 1996 mustang?

No, they are different body styles.

People also asked